DEVELOPMENT KIT Xkit Sheets/Sigfox/Sigfo… · The perfect way to get started with Sigfox, the...
Transcript of DEVELOPMENT KIT Xkit Sheets/Sigfox/Sigfo… · The perfect way to get started with Sigfox, the...
1
The perfect way to get started with Sigfox, the Thinxtra devkit Xkit boasts a full suite of features and accessories to empower anyone to set up an IoT solution, even with very little hardware experience. Perfect for start-ups, design houses, universities and schools, the kit has everything you need to hit the ground running using the globally available Sigfox network.
It has the following embedded sensors: • Accelerometer 3-axis• Digital Temperature and Pressure Sensor• Reed Switch• Light Sensor• LEDs Red & Blue• Push Button
Included as well to make it fully functional:USB Cable, Battery holder, Antenna, Arduino Uno R3 board clone, and 1 year connectivity to Sigfox network.
The shield board is compatible with Arduino board (or clone), PC, STMicro Nucleo board & Raspberry Pi. Available module options: Sigfox RCZ1| RCZ2 | RCZ4.
Device MakersDevelopers
www.thinxtra.com/Xkit
System Integrators Start-upsIncubators Hackathons
APPLICATIONS
DEVELOPMENT KIT Xkit
2
XKIT FEATURESTECHNICAL SPECIFICATIONS
Model Number XKIT1-1 | XKIT1-2 | XKIT1-4
Power Source USB port or 1x 9v PP3 battery not included
Wireless Frequency Options 868Mhz (RCZ1) | 902Mhz (RCZ2) | 920Mhz (RCZ4)
Wireless protocol Wisol module WSSFM10 - Sigfox uplink / downlink
Shield compatibility Arduino, Raspberry Pi, PC, STMicro Nucleo board, Freescale devboard Max Size (exc.antenna) 53.34mm width x 65.34mm length x 20.7mm height
SENSORS SOLDERED ON SHIELD
3-Axis accelerometer Smart, micromachined accelerometer with 14 bits of resolution
Shock sensor Reed switch
Digital temperature & pressure sensor
Pressure range: 300 - 1100 hPa ±0.12 hPa, Temperature range: -40°C - +85°C ±1.0
Ambient Light sensorBuilt-in photodiode and current amplifier circuit. Automatic control of display luminosity relative to ambient brightness. Spectral response similar to human eye.
Extras 2 LEDs (1 red, 1 blue), push button, male USB port
INCLUDED IN XKIT (aside Thinxtra shield)
Arduino board Uno R3 board clone included (you plug the Thinxtra shield into it)
Sigfox connectivity 1 year included
Extras USB cable (to program Arduino board), Battery holder
Antenna External swivel antenna, 85 cm length
www.thinxtra.com/Xkit
SHIELD FRONT VIEWw
idth
: 53.
34m
m
length: 55.34 mm
USB port
Antenna plug
SHIELD BACK VIEW
Wisol module
3 axis accelerometerDigital temperature & pressure sensor