Dektite Multicable Solar Flashing -...

1
w ww.deks.co.uk A Skellerup Industries Company Dektite Multicable Solar Flashing Installation Instructions Fit the acrylic lead apron in the same way as a convenonal lead weathering slate. The area where the les or slates have been cut or moved should be completely covered. It will normally be inserted under the les or slates above the penetraon and dressed over the adjoining les or slates as shown below. The cables should be passed through the ashing as follows: 1) Check exact outside diameter of the cables. 2) Cut the nipples as indicated for 4-6mm or 6-8mm cables. Use n snips or scissors ensuring that the cut is straight and parallel to give a ght t to the cable. DO NOT pierce the cable nipple with a craknife or other pointed implement. 3) Product code Base size Roof pitch Material DNLS10MB 4-8mm 490 x 410mm 0-45° EPDM/lead base SDA10MB 4-8mm 490 x 410mm 0-45° EPDM/aluminium base Pass cables through using water as a lubricant if needed. Cable Diameter

Transcript of Dektite Multicable Solar Flashing -...

Page 1: Dektite Multicable Solar Flashing - Solartricitystatic.solartricity.ie/wp-content/uploads/2014/07/Dektite-Solar... · Dektite Multicable Solar Flashing Installation Instructions Fit

www.deks.co.uk

A Skellerup Industries Company

Dektite MulticableSolar Flashing

Installation InstructionsFit the acrylic lead apron in the same way as a conventional lead weathering slate. The area where the tiles or slates have been cut or moved should be completely covered. It will normally be inserted under the tiles or slates above the penetration and dressed over the adjoining tiles or slates as shown below.

The cables should be passed through the flashing as follows:

1) Check exact outside diameter of the cables. 2) Cut the nipples as indicated for 4-6mm or 6-8mm cables. Use tin snips or scissors

ensuring that the cut is straight and parallel to give a tight fit to the cable. DO NOT pierce the cable nipple with a craft knife or other pointed implement.

3)

Product code Base size Roof pitch Material DNLS10MB 4-8mm 490 x 410mm 0-45° EPDM/lead base SDA10MB 4-8mm 490 x 410mm 0-45° EPDM/aluminium base

Pass cables through using water as a lubricant if needed.

Cable Diameter