Rig: XXXX Connection Procedure Competent Rock Rev.: Rev 0Well: XXXX Date: 20/06/2015

Signatures Drilling Supervisor: ___________________ Toolpusher: ___________________

Distribution Drilling Supervisor, Drilling Engineer, 2 x Driller, 2 x Assistant Driller, SLB LMWD, SLB GEO, Halliburton Turbine

Objective 1. Effective hole-cleaning with consistentconnection practice

2. Minimise off-bottom work to maintain a gaugehole for good hole cleaning and trippingconditions

# Operational Description Comments

1.

Drill stand down Driller to inform on radio when connection passes

table for depth calibration do not stop

Verify depth

2.

Pull off bottom + 2m using max 1 min Keep drilling RPM Keep 100% flow Read torque and weight as required

Full drilling parameters for maximum hole-cleaning.

3. Stop rotation

4.

P/U and record stable up and down weight Pull up 3-5 m and go down, max 10 m/min 100% flow moving up If ECD is high, stop 10sec on top before moving down 100% flow moving down if conditions allows (else

80% flow moving down) Stop pumps

100% flow to maintain hole-cleaning.

5.

Set slips on downward movement and make connection Fill pipe immediately w/400-1000lpm* while M/U

connection Do not start rotation

* Dependent on hole condition and hole size.

Minimize static time to avoid settling of cuttings.

6.

Survey and Start up sequence When returns increase to 100% flow (max 1 min) Open slips Open compensator if required Wait 30-45 seconds after reached minimum turn on

flow for MWD (300 gpm) Increase to drilling RPM

If delayed survey is used, go directly to drilling withoutwaiting on (IN-SYNC)

Obtain survey and apply hole cleaning parameters as fastas possible.

7.Drill ahead

Check pressure response when going on bottomAvoid going on bottom too fast.

Excellent consistency