CLICK ON NEW FORM

1. RESIZE THE FORM2. RENAME THE FORM AS “CyclePage1”

1. CLICK ON <QReport>2. CLICK ON <QuickRep>

(first item)3. PLACE <QuickRep> ON

THE FORM4. RESIZE <QuickRep> TO

FIT THE FORM

JUST CARRY THE CORNER OF <QuickRep> TO THE CORNER OF THE FORM

1. DOUBLE CLICK ON <+Page>2. CHANGE <PageSize>TO A43. CHANGE ALL MARGINS TO 25mm

1. CLICK ON <QRBand> (4th item)2. PLACE THE ITEM ON <QuickRep>

PULL <QRBand> ALL THE WAY DOWN TO

THE END OF <QuickRep>

NOW YOU MAY PLACE•QRLABEL•QRMEMO•QRRICHTEXT•etc

IF YOU ARE GOING TO PASTE AN IMAGE OF A PAGE AND THEN FILL

IN THE BLANKSTHEN

ITS A GOOD IDEA TO LOWER ALL THE MARGINS DOWN TO ZERO

YOU MAY ALSO PASTE AN IMAGE AND THEN PLACE QRLABEL etc ON IT

DO NOT TRY TO PREVIEW AN IMAGEIF YOU DO THEN DELPHI WILL CRASHAND YOU WILL LOSE ALL UNSAVED DATA

PASTE AQRIMAGE

FIRST PLACE A <QRBAND> OBJECT

AND THEN STRETCH IT ACROSS

QUICKREP1AND THEN PASTE

A <QRIMAGE> OBJECT

THEN START STRECHING IT ALL ACROSS THE SHEET

DOUBLE CLICK ON THE IMAGE

AND PRESS “LOAD” ON THE

DIALOG BOX AND CHOOSE THE JPG

IMAGE OF THE PAGE

FOR EXAMPLE PICK P1.JPG FROM THE LINER FOLDER IN

THE DESIGNPAGES FOLDER

MAKE THE “STRETCH”

PROPERTY OF QRIMAGE1 <TRUE>

NOW JUST PLACE THE QRLABEL

OBJECTS

OPEN A NEW UNIT AND SAVE

IT AS “PRINTVAR”

PLACE THE PROCEDURES FOR

SETTING THE QRLABELS IN THIS

UNIT

THIS UNIT SHOULD USE THE FOLLOWING

UNITS

AT THIS STAGE ITS EMPTY

OFCOURSE

Let us try to prınt the value of the maximum pressure :

1. PLACE A QRLABEL OBJECT AND NAME IT AS “QRLabel_Pmax”

NORMALLY OFCOURSEYOU WILL PLACE MANYQRLABEL OBJECTS AND

NAME THEM MEANINGFULLY

IN THE “PRINTVAR” UNIT WE DECLARE A PROCEDURE

<PRINTLINERPAGE1>AND THEN IN THE

IMPLEMENTATION SECTION WE SET THE CAPTION OF “L”

AND PRINT “QR” WHICH IS ACTUALLY <QUICKREP1> OF

<Liner_Page_1>

IN UNIT MAIN WE WILL ADD AN INSTRUCTION

FOR PRINTING THE LINER PAGE

“Liner_Page_1” IS THE NAME WE GAVE TO THE

FORM ON WHICH <QUICKREP1> OBJECT IS

PLACED