CCNA 4 v3. 1 Module 4
description
Transcript of CCNA 4 v3. 1 Module 4
1
CCNA 4 v3.1 Module 4
2
CCNA 4 v3.0 Module 4ISDN and DDR
333
Objectives
• ISDN concepts• ISDN configuration• DDR configuration
444
Digital Communication with ISDN
555
ISDN Benefits
666
ISDN Standards
777
ISDN Access Options
888
ISDN 3-Layer Model
999
Q.931 Messaging-Call Setup Example
101010
Call Processing
1. The D channel is used to send the called number to the local ISDN switch.
2. The local switch uses the SS7 signaling protocol to set up a path and pass the called number to the remote ISDN switch.
3. The remote ISDN switch signals the destination over the D channel.
4. The destination ISDN NT-1 device sends the remote ISDN switch a call-connect message.
5. The remote ISDN switch uses SS7 to send a call-connect message to the local switch.
6. The local ISDN switch connects one B channel end-to-end, leaving the other B channel available for a new conversation or data transfer. Both B channels can be used simultaneously.
111111
ISDN Functions and Reference Points
121212
ISDN Functions and Reference Points
131313
BRI Reference Points
141414
Cisco ISDN BRI Interfaces
151515
ISDN Interfaces
S/T ISDN Interface
U ISDN Interface
161616
ISDN Switch Types
171717
Configuring ISDN BRI
181818
Configuring ISDN BRI
191919
Configuring ISDN PRI
202020
Switch Types Available for ISDN PRI Configuration
212121
ISDN PRI Examples
222222
Verifying ISDN Configuration
232323
Troubleshooting ISDN Configuration
242424
DDR Operation
252525
DDR Operation
262626
Configuring Legacy DDR
272727
Defining Static Routes
• When configuring static routes, consider the following:
By default, a static route will take precedence over a dynamic route because of its lower administrative distance. Without additional configuration, a dynamic route to a network will be ignored if a static route is present in the routing table for the same network.
To reduce the number of static route entries, define a summarized or default static route
282828
Specifying Interesting Traffic – Dialer List
292929
Configuring Dialer Information – PPP
303030
The dialer-group Command
313131
The dialer-map Command
323232
The dialer idle-timeout Command
333333
Dialer Profiles Overview• Define encapsulation and access control lists• Determine minimum or maximum calls• Turn features on or off
343434
Dialer Profile Elements
353535
Configuring Dialer Interfaces
363636
Verifying DDR
• show dialer
• show dialer interface [BRI]
• show isdn active
• show isdn status
373737
Troubleshooting DDR
• debug isdn q921
• debug isdn q931
• debug dialer [events|packets]
• isdn call interface
• clear interface bri