Car Cool

6
Carcool

description

carcool peltier device

Transcript of Car Cool

Carcool

IntroductionCarcool is a divice to

Peltier Cooler

DESCRIPTIONKeep it cool with a Peltier module. These unique electronic components can generate a temperature differential when powered. That is to say, apply 5V to the red (positive) and black (negative) wires and one side will get cold while the other side gets hot. For best results, you'll need to wick away that heat (otherwise the cold side will slowly get warmer). A fan and/or heatsink is ideal.

This module is a 5V module, and is rated for 5W max (5V/1A) but when we plugged them in they seemed to draw more like 1.5A so we suggest our 5V/2A power adapter for use.

TECHNICAL DETAILS

. Max current: 1.5A @ 5V. Suggested Voltage range: 5V to 7V. Maximum temperature differential (Tmax @ Qc = 0): 65C. 127 Peltier elements. DC Resistance: 2.5 ohms. Silicone seal. Dimensions: 30mm / 1.18" x 30mm / 1.18" x 3.29mm / 0.12". Wire Length: 289.56mm / 11.4". Weight: 11.43g

Heat sink

Dimensions: 3.35 in x 2.76 in x 2.76 inWeight: 9.63 oz

5V TP4056 Lithium Battery Charging ModuleDescription

Charge module: Linear charging. Current: 1A (Adjustable) Charge precision: 1.5% Input voltage: 4.5V-5.5V Full charge voltage: 4.2V LEDs: red - charging | green - charged. Input interface: mini USB and Solder plates Work temperature: -10C to 85C Inversed polarity: NO Small Size: 27mm x 19mm x 5mm. (LED Colors may vary)

This is not meant for charging a battery from a USB Port from a computer. A USB Port will only source 500mA max. If you want to use this to charge from a USB port you would have to replace the resistor which is explained below. Even then, we have not done tests to know if this will make using a USB computer port an option with this board. An ampere meter can only be connected to 5v input end of the module. When charging it is better that the charging current is 37% of the battery capacity. So if you charge to the battery of 1000mAH, current of 400 is enough. Make sure you use a proper gauge wire for the current being used. Too thin and it will burn, too thick and the circuit may not act correctly. Make sure the connection at the contract points are good. If the input voltage is too high, like 5.2v, the current will be less than 1000mA, it is a normal protection function. NO Reverse polarity, connecting the battery the wrong way will fry the chip. The current can be altered (lowered) by changing the resistor connected to pin 2 of the IC (at the bottom middle of the board in relation to the direction of the text). In the configuration the module ships with the current is 1A. Changing out the surface mount resistor with a higher resistance will lower the current. The chart below will give you estimates of some resistor to current values:OhmsmA

30K50

20K70

10K130

5K250

4K300

3K400

2K580

1.66K690

1.5K780

1.33K900

1.2K1000

http://www.atomsindustries.com/ASD1020