Installation

ATTENTION: To prevent electrical shock, disconnect from power source before installing or servicing. Install in suitable enclosure. Keep free from contaminants.ATTENTION: Avant le montage et la mise en service, couper l'alimentation secteur pour éviter toute décharge. Prévoir une mise en co�ret ou armoire appropriée. Protéger le produit contre les environnements agressifs.ACHTUNG: Vor Installations- oder Servicearbeiten Stromversorgung zur Vermeidung von elektrischen Unfällen trennen. Die Geräte müssen in einem passenden Gehäuse eingebaut und gegen Verschmutzung geschützt werden.ATENCION: Desconéctese de la corriente eléctrica, antes de la instalación o del servicio, a �n de impedir sacudidas eléctricas. Instálelo en una caja apropiada. Manténgalo libre de contaminantes. ATTENZIONE: Per prevenire infortuni, togliere tensione prima dell'installazione o manutenzione. Installare in custodia idonea. Tenere lontano da contaminanti.

1 TYPE 1 (IP42)

1 2

TYPE 1 (IP42)

TYPE 12 (IP65) or TYPE 4 (IP66)

(22.2 mm)7/8 in.

(¿3.6mm)9/64¿

(11.1 mm)7/16 in.

Bulletin 198 Pilot Device Kit Installation(Cat 198-SSPB, -2SS, -3SS, -FRSPB, -RUPL, -GUPL, -WUPL, -R240PL, -G240PL, -W240PL, -ESP)

Rockwell Automation maintains current product environmental information on its website athttp://www.rockwellautomation.com/rockwellautomation/about-us/sustainability-ethics/product-environmental-compliance.page

1- 2,8 mm

12

3

Enclosure

*Selector Switch shown

Additional Notes: -Always plug in Command Device �rst -Plug in Light Devices second -If applicable, replace E-stop jumper with E-stop device -If applicable, plug in Auxiliary device next -Connect Molex plugs together last

PN-290726DIR 10001446898 (Version 00)Printed in MexicoPublication 198-IN015A-EN-P - January 2015

2