Page 5

Automation Interface Module (AIM) Worksheet

Communications Interface Module (CIM) Worksheet

Directions: Fill in section 1: Document the desired status and control points for each lighting panel. Please indicate the # of relays in each panel and

whether you would like to just check status or if you would also like to issue commands. If the panels have the same command and status requirements,

you may submit one sheet that has all applicable panels listed in the space provided at the bottom of this section. Fill in section 2 on one sheet only.

Section I Relay Outputs Local Contact Inputs

Relay

Check Relay Status

Issue Relay Commands

If you wish to issue commands to this relay as part of a command group, please indicate group #

that this relay belongs to. Notes Input

Check Input

Status Notes

01 01

02 02

03 03

04 04

05 05

06 06

07 07

08 08

09 09

10 10

11 11

12 12

13 13

14 14

15 15

16 16

17 17

18 18

19 19

20 20

21 21

22 22

23 23

24 24

25 25

26 26

27 27

28 28

29 29

30 30

31 31

32 32

33

34

35

Analog Input

Check Input

On/Off Status Check Analog Reading

36

37

38 01 39 02 40 03 41 04 42

43

44

45

46

47

48

Section II Setup Information (Fill in on one sheet only and choose only one protocol)

Automation Interface Module (AIM) Communications Interface Module (CIM)

What Protocol will you be using? (circle one) BACnet Modbus LON N2

BACnet

I will be using BACnet over IP I will be using BACnet over Ethernet (Please provide the following information for proper (Please provide the following information for proper configuration) configuration. Please note – the MAC address

information of the unit will be provided on the final

IP Address mapping table once the unit is configured)

Subnet Mask BACnet Network Number

Default Gateway IP Address Desired BACnet Device Object Instance ID#

Desired BACnet Device Object Instance ID#

I will be using BACnet over ARC156 I will be using BACnet over MS/TP (Please provide the following information for proper (Please provide the following information for proper configuration) configuration)

Desired ARCnet Address Desired MS/TP Address

BACnet Network Number BACnet Network Number

Desired BACnet Device Object Instance ID# Desired BACnet Device Object Instance ID#

What is the desired baud rate

What is the desired Max Master setting? (default is 127)

Modbus Choose Protocol Configuration: Baud Rate Data Bits Expected

Choose Protocol Configuration Baud Rate Data Bits Expected

RTU 1200 8

ACCII 2400 7

4800

Choose Com Type 9600 Stop Bits Expected

RS232 19200 1

2wire RS485 38400 2

4 wire RE485/422

Parity

Indicate Desired Slave Address Odd

Even

None

N2 What N2 slave address should be assigned to the AIM? (This address must be different from any other N2 device on the N2 BUS.)

LON No additional Information needed