3D Micromanufacturing Lab.[1]

Drying Oven

[2] 3D Micromanufacturing Lab.

What is a Drying Oven• An oven is a thermally insulated chamber used for the heating or drying

of a substance using hot air that flows inside the oven.

• When the pipette tips are autoclaved then water droplets are adhered on the tips.

• This water droplets could change the concentration of solutions which is handled by using pipette.

• In our lab, majorly we use this oven to dry the pipette tips after they have been autoclaved.

[3] 3D Micromanufacturing Lab.

Settings

• Normally, this drying oven is set at 60°C for 3-4 hours to dry water droplets from pipette tips.

• Temperature and timer can be set by pressing ‘Mode’ and then changing the values using ‘left’ and ‘up’ keys.

[4] 3D Micromanufacturing Lab.

SpecificationsMODEL HST-501S

  Dimension (IN) 450x450x450 (H) mm

                 (OUT) 550x580x800 (H) mm

  Capacity 91 Litre

  Shelves 2 EA

  Temp. controller Digital PID Controller

  Temp. Range Ambient +5' C to 220'C

  Temp. Accuracy ± 1.5 'C at 100'C

  Temp. Sensor PT100Ω

  Timer Digital Timer 99hr 59min. or Infinity

  Material (IN) Stainless Steel (SUS304) Polishing Plate

              (OUT) SCP-1 With Powder Coating

  Door Silicon Packing Door With Window

  Safety Device Hydraulic Temperature Controller

  Port Exhaust Hole x 2EA

  Power (AC 220V, 60HZ) 800W