2A D110 igita reamplifie utpu onnection iagra whe se A it ...
2
2A McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549 Part No. 04172600 D1100 Digital Preamplifier Output Connections Diagram (when used as a DAC with an Analog only Preamplifier) Note: Refer to the D1100 Owner’s Manual page 8 for additional connection information. Connection Legend: Data Cable*- Digital Signal Cable - Sensor/Keypad Cable - RS232 Cable - Power Control Cable* - Ground Wire - Audio Signal Cable - AC Power Cords - Video Signal Cable - Loudspeaker Cable - RF Signal Cable - * 2 conductor shielded with 1/8 inch stereo mini phone plug on each end. + Connect to AC Outlet Connect to AC Outlet Right Loudspeaker System Left Loudspeaker System - + - Power Amplifier - Primary Room Analog Preamplifier Connected to the Analog (Preamplifier) Controller Main Power Control Out Jack TO CONTROLLER RIGHT INPUT TO CONTROLLER LEFT INPUT
Transcript of 2A D110 igita reamplifie utpu onnection iagra whe se A it ...
2A
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549 Part No. 04172600
D1100 Digital Preamplifier Output Connections Diagram (when used as a DAC with an Analog only Preamplifier)
Note: Refer to the D1100 Owner’s Manual page 8 for additional connection information.
Connection Legend: Data Cable*- Digital Signal Cable - Sensor/Keypad Cable - RS232 Cable - Power Control Cable* - Ground Wire - Audio Signal Cable - AC Power Cords - Video Signal Cable - Loudspeaker Cable - RF Signal Cable - * 2 conductor shielded with 1/8 inch stereo mini phone plug on each end.
+
Connect to AC Outlet
Connect to AC Outlet
Right Loudspeaker System
Left LoudspeakerSystem
-+-
Power Amplifier - Primary Room
Analog Preamplifier
Connected to the Analog (Preamplifier) Controller Main Power Control Out Jack
TO CONTROLLER RIGHT INPUT
TO CONTROLLER LEFT INPUT
2B
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549
D1100 Digital Preamplifier Output Connection Diagram (when used as a stand alone Preamplifier)
6.6
Note: Refer to the D1100 Owner’s Manual page 9 for additional connection information.
Connection Legend: Data Cable*- Digital Signal Cable - Sensor/Keypad Cable - RS232 Cable - Power Control Cable* - Ground Wire - Audio Signal Cable - AC Power Cords - Video Signal Cable - Loudspeaker Cable - RF Signal Cable - * 2 conductor shielded with 1/8 inch stereo mini phone plug on each end.
+
Connect to AC Outlet
Power Amplifier - Secondary Room
Connect to AC Outlet
Connect to AC Outlet
Right Loudspeaker System
Left LoudspeakerSystem
Right Loudspeaker System
LeftLoudspeaker System
-+-+ -+-
Power Amplifier - Primary Room
From Phono Preamplifier PWR CTRL Trig Out
