Каталог 2013 крепление+короба...

E-mail: [email protected] Tel: +7 (495) 777-75-06, Fax: +7 (495) 673-81-86 1

CABLE CLAMPS

CABLE CLAMPS FOR HIGH VOLTAGE CABLES

ApplicationFastening of all types of medium ,high and extra high voltage cables.

Material Polyamide, fiberglass-reinforced, coloured black, flame resistant, special protection against ultraviolet rays, free of halogenes, fully recycable.

Service conditionsThe climatic category is temperate and cold climate, the placement category is 1 and 2 based on Russian Standart 15150-69.The fiberglass-reinforced polyamide used in manufacture is marked by particularly high mechanical strength and heat resistance. Implementation both indoor and outdoor due to resistance to ageing, ozone and ultraviolet rays. No alteration in strength within a temperature range of -60 to 60° C.

Cable clamps for all types of single- and multi-conductor cables fastening of each phase separatly. Series RKK. Mechanical resistance to short-circuits - 10 000 Н

Series VKK. Mechanical resistance to short-circuits - 20 000 Н

Fastening of single-conductor cables in trefoil arrangement. Series UKK-60. Mechanical resistance to short-circuits - 10 000 Н

Series UKK3. Mechanical resistance to short-circuits - 40 000 Н

Series VKK3. Mechanical resistance to short-circuits - 40 000 Н

Type: Outer cable diameter:

VKK-65/90 65 - 90 mm

VKK-85/105 85 - 105 mm

VKK-100/125 100 - 125 mm

VKK-125/150 125 - 150 mm

VKK-145/170 145 - 170 mm


RKK-25/40 25 - 40 mm

RKK-40/60 40 - 60 mm


UKK-60, UKK2-60 30 - 40 mm


UKK-35/55 35 - 55 mm

UKK-40/70 40 - 70 mm


VKK3-65/90 65 - 90 mm

VKK3-85/110 85 - 110 mm

VKK3-110/135 110 - 135 mm

The RKS-Plast company reserves the right for change and addition of a model range of fastenings. Information in the catalog is help. You can learn more detailed and actual information on company products on a site www.rks-plast.ru

RKS-Plast Ltd. 111024, Moscow, 2nd Kabelnaya St., 2, p. 9 www.rks-plast.ru

CABLE CLAMPS

2

Line cable clamps series RKK

Cable clamps for voltage cables series VKK

Type: L I h a b R d weight,grams

VKK-65/90 175 140 50 19 14 46 13 370

VKK-85/105 185 150 64 20 11 53 13 474

VKK-100/125 204 170 67 19 14 63 13 446

VKK-125/150 234 200 81 20 14 75 13 590

VKK-145/170 250 214 91 19 14 85 18 630

Type: Lu Ld I d c a b g Rh

weight,gramsmin max

RKK-25/40 90 83 60 11 55 23 17 40 25 50 70 150

RKK-40/60 120 113 90 11 55 30 17 55 32 65 95 225

For obtaining detailed information address to our consultant

Fastening represents two profiles between which the cable is clamped. Profiles are supplied with the reinforced ribs providing mechanical strenght and resistance to load impact at short circuit. Profiles from two partis have holes for fastening to a metalwork.

Fastening represents two replacement clamps. C are supplied with the providing mechanical strenght and resistance to shock load impact at short circuit. Paws of clamps from two parties have openings for product fastening to a metalwork. Fastening is issued in various standard sizes.

lampsreinforced ribs


CABLE CLAMPS

Series UKK-60Fastening represents two replacement profiles. Profiles are supplied with the reinforced ribs providing mechanical strenght and resistance to load impact at short circuit. On an external surface of a profile there is a knot for product fastening to a metalwork.

Series UKK2-60Cable fastenings of the UKK2-60 brand are specially developed as completing to cable fastenings of UKK-60, for fixing of several cable lines on the shelf.

When using UKK2-60 complete with UKK-60 the occupied space on the assembly shelf is reduced, strenght of all design increases, the number of fastening elements is reduced.


CABLE CLAMPS

4 RKS-Plast Ltd. 111024, Moscow, 2nd Kabelnaya St., 2, p. 9 www.rks-plast.ru

Universal cable series KK3clamps U

The product is designed in such a way that with the maximum diameters of a cable, for this type of fastenings, the top and bottom parts are in continuous gearing that reduces bending loads of the fastener and by that, increases the general durability of all design to mechanical loadings at emergence of currents of short circuit.

Cable clamps for high voltage cables series VKK3

The product is designed in such a way that with the maximum diameters of a cable, for this type of fastenings, the top and bottom parts are in continuous gearing that reduces bending loads of the fastener and by that, increases the general durability of all design to mechanical loadings at emergence of currents of short circuit.

Type: L I d c a b g Rh H

weight,gramsmin maxmin max

VKK3-65/90 290 234 18 80 95 130 135 32,5 166 225 198 260 2415

VKK3-85/110 330 274 18 80 95 155 150 42,5 166 236 226 296 3080

VKK3-110/135 380 324 20 80 100 190 155 55 175 245 265 335 3470


Type: Lu Ld I d ch weight,

grams

min max

UKK3-35/55 176 176 134 13 70 100 152 755

UKK3-40/70 213 213 173 13 70 120 190 1196


ELASTIC INLAY

PST-80 (elastic inlay)

ApplicationFixation of cables and support of weight in vertical installations

Material Silicone gasket is made of organosilicon.

Service conditionsThe climatic category is temperate and cold climate, the placement category 1 and 2 basedon Russian Standart 15150-69.Implementation both indoor and outdoor due to resistance to ageing, ozone and ultraviolet rays. No alteration in strength within a temperature range of -60 to 60° C.

Fire safetyThe material of gasket doesn't sustain combustion.

Delivery rateIt is ordered in meters taking into account an expense on one fastening: 0,2 m - VKK; 0,3 m - UKK3; 0,4 m - VKK3.



EARTHING LINK BOX

6

Earthing link box type KZE is designed for direct earthing of three coaxial bonding cables, at the device of the line of 10-500 kV.

BASIC LINK BOX COMPONENTS-stainless steel box with sealed lid;-entrance for coaxial bonding cables with sealed cable glands;-earthing connection on link box;-surge arrester(standard, class of tension of a network of 6 kV);-support insulators (standard, rated voltage is 10 kV);-bus bars;-cable end fixing clamp.

TECHNICAL SPECIFICATION-Input node of the earthing wire to the device is designed so as to prevent ingress of moisture into the box, as well as to be able to insert and remove the device from the wire end without removing the ferrule.-Material of cable conductor - annealed copper-Use wire with conductor section of 400 mm ²

IN ADDITION -surge arrester and support insulators can be replaced if necessary (on demand);-protection class - IP54 (standart), IP68 (on demand).

KZE-О-3

-3KZE

KZE-О-1

-1KZE

Сonnection schemes

For additional information (characteristics, descriptions, specifications, drawings in the AutoCAD format) you can address by phone (495) 777-75-06 or e-mail [email protected].

E-mail: [email protected] Tel: +7 (495) 777-75-06, Fax: +7 (495) 673-81-86

EARTHING LINK BOX

7

KZE-О-3

KZE-3

- earthing of three coaxial bonding cables, at the device of the line of 10-500 kV.- Earthing wire in not supplied.- Earthing wire should have copper multiwire conductor with the cross-sections from 95 to 400 mm ² and the insulation withstand voltage of 10 kV DC.- Complete with fixing clamps for hexagon crimping on copper conductors section from 95 to 400 mm ².- Conductor cross-section of wire and the outer diameter must be specified when ordering boxes.- Entrance of wires of earthing and cable end fixing clamps are pressurized by thermoseated tubesCFM Raychman 56/16 black with glue (8 pieces on 100 mm), being included in the package deliveries.- Protection class: IP54, IP68.- Climatic performance UHL 1.- Housing box must be grounded in accordance with the PUE.- Approximate weight 37 kg.

Earthing link box type KZE-3 is designed for direct


- direct earthing of three coaxial bonding cables, at the device of the line of 10-500 kV.-The response surgearresters - 6 kV.- Earthing wire in not supplied.- Earthing wire should have copper multiwire conductor with the cross-sections from 95 to 400 mm ² and the insulation withstand voltage of 10 kV DC.- Complete with fixing clamps for hexagon crimping on copper conductors section from 95 to 400 mm ².- Conductor cross-section of wire and the outer diameter must be specified when ordering boxes.- Entrance of wires of earthing and cable end fixing clamps are pressurized by thermoseated tubesCFM Raychman 56/16 black with glue (8 pieces on 100 mm), being included in the package deliveries.- Protection class: IP54, IP68.- Climatic performance UHL 1.- Housing box must be grounded in accordance with the PUE.- Approximate weight 53 kg.

Earthing link box type KZE-O-3 is designed for


EARTHING LINK BOX

8

KZE-1

KZE-О-1


- direct earthing of three coaxial bonding cables, at the device of the line of 10-500 kV.-The response surgearresters - 6 kV.- Earthing wire in not supplied.- Earthing wire should have copper multiwire conductor with the cross-sections from 95 to 400 mm ² and the insulation withstand voltage of 10 kV DC.- Complete with fixing clamps for hexagon crimping on copper conductors section from 95 to 400 mm ².- Conductor cross-section of wire and the outer diameter must be specified when ordering boxes.- Entrance of wires of earthing and cable end fixing clamps are pressurized by thermoseated tubesCFM Raychman 56/16 black with glue (4 pieces on 100 mm), being included in the package deliveries.- Protection class: IP54, IP68.- Climatic performance UHL 1.- Housing box must be grounded in accordance with the PUE.- Approximate weight 27 kg.

Earthing link box type KZE-O-1 is designed for

- earthing of three coaxial bonding cables, at the device of the line of 10-500 kV.- Earthing wire in not supplied.- Earthing wire should have copper multiwire conductor with the cross-sections from 95 to 400 mm ² and the insulation withstand voltage of 10 kV DC.- Complete with fixing clamps for hexagon crimping on copper conductors section from 95 to 400 mm ².- Conductor cross-section of wire and the outer diameter must be specified when ordering boxes.- Entrance of wires of earthing and cable end fixing clamps are pressurized by thermoseated tubesCFM Raychman 56/16 black with glue (4 pieces on 100 mm), being included in the package deliveries.- Protection class: IP54, IP68.- Climatic performance UHL 1.- Housing box must be grounded in accordance with the PUE.- Approximate weight 20 kg.

Earthing link box type KZE-1 is designed for direct

E-mail: [email protected] Tel: +7 (495) 777-75-06, Fax: +7 (495) 673-81-86

CROSSBONDING LINK BOX

9

- Crossbonding link box KTK-3 is designed for a transposition of screens of power cables of 110-500 kV.- The response surgearresters - 6 kV.- Wires transposition and earthing wire are not included.- Wires for transposition of the screens and the earthingwire should be copper, stranded wire sizes from 95 to 400 mm ² and the insulation withstand voltage of 10 kV DC.- Complete with fixing clamps for hexagon crimping on copper conductors section from 95 to 400 mm ².- Conductor cross-section of wire and the outer diameter must be specified when ordering boxes.- Entrances of wires of a transposition are pressurized by thermoseated tubes CFM Raychman 85/25 black with glue (6 pieces on 200 mm), being included in the package deliveries.- Cable end fixing clamps are pressurized by thermoseated tubes CFM Raychman 56/16 black with glue (7 pieces on 200 mm), being included in the package deliveries.- Protection class: IP54, IP68.- Climatic performance UHL 1.- Housing box must be grounded in accordance with the PUE.- Approximate weight 66 kg.

For more information (characteristics, descriptions, specifications, drawings in the AutoCAD format) you can address by phone (495) 777-75-06 or e-mail [email protected].

KTK-3

Connection scheme

Каталог 2013 крепление+короба...

Documents

Transcript of Каталог 2013 крепление+короба...