Post on 13-Apr-2017
Launch SimDataStudio
This short guide shows how to run WAG simulation using Nexus. It is assumed you already have Nexus model built and WAG process needs to be applied.
Go to EXEC data Tab, choose Well Constraints → Well Type
Double click on well. Select Well Type window will appear
Choose Water alternating gas and spesify WAG control procedure and parameters
Go to Constraint Maximum Rate
Double click on well. Select Well Rate Constraint for water and gas injection
Click to generate Nexus files
Check _surface.dat file to see WAG description
Click Nexus Job to set the job and Start to run the model
Check results using SimResults