Post on 28-May-2020
How to set up a new inverter
REFUsol 100K
REFUstore 50/88K
by using REFUset Application via Bluetooth® connection
Download REFUset application (iOS or Android)
Visit App Store or Play Store and Download REFUset app for your mobile or tablet.
Enable Bluetooth communication on your device.
REFUset app_Setup inverter_EN_2019.06.19_Kostas Kontogiannis
Connect your mobile to inverter
REFUset app_Setup inverter_EN_2019.06.19_Kostas Kontogiannis
Once you are ready, approach inverter and press the Bluetooth Connect icon.
Icon will start blinking.
Launch REFUset app on your mobile.
Application will scan for available inverters.
Connect your mobile to inverter
REFUset app_Setup inverter_EN_2019.06.19_Kostas Kontogiannis
You will be requested to pair your mobile with inverter.
Select “Pair”.
Then your mobile will connect to inverter.
Bluetooth Connect icon will become stable blue.
Inverter setup – Country and grid settings
REFUset app_Setup inverter_EN_2019.06.19_Kostas Kontogiannis
Setup window will request you to select:
• Country
• Grid Code
• Nominal grid voltage
Once you select the correct options, click on “Next”
Inverter setup – Communication settings
REFUset app_Setup inverter_EN_2019.06.19_Kostas Kontogiannis
In next window you can enter communication settings.
You can choose between Ethernet or RS485
Inverter setup – Communication settings - Ethernet
REFUset app_Setup inverter_EN_2019.06.19_Kostas Kontogiannis
In case you have Ethernet communication you can choose between:
• Manual: you have to enter the IP address you want to assign to this inverter
and the Subnet mask and Standard gateway of the network it will be
connected.
• DHCP: inverter is adjusting automatically the IP configuration.
Inverter setup – Communication settings – RS485
REFUset app_Setup inverter_EN_2019.06.19_Kostas Kontogiannis
In case you have RS485 communication you can choose between:
• REFU USS
• Sunspec Modbus
Then you have to enter:
• Bus address
• Baud rate
• Parity
• Stop bits
Inverter setup – Store settings
REFUset app_Setup inverter_EN_2019.06.19_Kostas Kontogiannis
When you finish, click on “Save”.
Inverter will store the new settings and restart.
After that, it will be ready to operate.
Note:
In case communication cabling of the installation is not ready at the time of
commissioning, you can click on “Save” without making any modifications.