Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

Software Technologies Pvt.Ltd.

#22, Divyashobha, 100 Ft Ring Road,

3rd Phase, 6th Block, BSK 3rd Stage,

Bangalore , India, PIN Code 560 085

Phone: +91 80 2679 9382

Email: services@conceptia.in

www.conceptia.in

ENGINEERING SERVICES-STRUCTURAL ANALYSIS

1

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

AIM To understand the structural stability of the sea valve using FEA analysis technique for following test criteria 2 kgf / cm2 pressure against the valve shutter for 30 minutes

SEA VALVE

MODEL STRESS PLOT DISPLACEMENT PLOT

2

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

Delivery: Analyzed stress developed and the displacement.

Compared with GES. Recommended additional stiffeners, revised stress and displacement and

engineering drawings

Covenant Standards: IS 800:2007 & GES

TURBINE CASING

AIM

To analyze the given structure to bear the operating loads (Shaft and generator

assembly seated at top of housing )

3

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

FATIGUE ANALYSIS

Approach: Good man diagram technique Analyzed stress is 200MPa, according to the SN curve 2 x 106 cycles for 300 MPa, confirmed the part is safe for intended life Covenant Standards: Publications and ASTM

AIM

Life estimation of the Pelton turbine bucket due to cyclic water jet impingement

4

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

AIM

To check the structural integrity of under deck structural members of the single bollard for the given design load conditions. Verifying the existing structural design is strong enough to withstand the design load, if inadequate provide alternate design to under deck portion to withstand the design load.

SINGLE BOLLARD

Existing Model Proposed Model

5

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

AIM

U124 Panel has to be analyzed by FEA method to determine stresses and displacement when it is lifted.

LIFTING ANALYSIS

Model

Mesh pad eye arrangement

6

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

The max stresses are in the pad eye and the panel is observed to be stressed about 28 MPa. The maximum displacement of the panel is 0.5mm. Considering the displacement with load augmentation factor (with CS Poisson’s ratio) the displacement is estimated to be less than 0.6mm. Thus provisioning of pad eyes as shown is safe for lifting of the panel.

RESULT PLOTS

7

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

AIM

To analyse the structural strength of universal frame used for transportation of rings.

Original model

LIFTING RING FOR TRANSPORTATION

Combination of Axial & Bending stress

Displacement

8

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

• Structure is lifted by using four vertically positioned lifting eyes • Materials are isotropic in nature and loading condition is symmetrical • Maximum value of displacement = 0.0021 inch • Maximum Stress observed on the lifting Eye = 9250 Psi

LIFTING EYE ANALYSIS

9

AIM To analyze the structural soundness of the lifting eyes attached to the frame to lift the whole structure including the ring.

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

AIM

To arrive at locking load to ensure proper sealing with a rubber gasket considering permanent deformation and hysteresis of rubber gasket. Also estimation of life due opening and locking.

RESULTS

Locking load and fastener design with FOS Analyze at this load rubber compression and likely deformation using hysteresis curve for a given period of loading. Check for availability of residual compressibility for same load so that effective sealing is maintained after given number of operations.

COVER STRESS PLOT

GASKET ANALYSIS

10

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

DROP TEST

BATTERY COVER

Output: Independently analyzed stress due to impact

load on all six faces plus corner .Identified corner

impact has highest stress generated. Small change in

Battery holding arrangement within pack improved

ability to withstand shock.

Standard :BR 3021 & IS13035

Plot step - 1 Plot step - 2 Plot step - 5 Plot step - 10 Plot step - 15 Plot step - 25

AIM

To find the structural integrity of Battery pack assembly under impact due to fall /

drop from 0.75m of height.

11

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

AIM

1. Verification of strength of the component designed using plastic.

2. To determine locking pin strength/adequacy.

NON LINEAR STRENGTH

12

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

Manufacturing CAD/CAE Analysis Design & Support Service

• Access Solutions • Reengineering • Retro fitment • SPM – Concept to

delivery

CFD Analysis • Thermal • Hydraulic • Lift & Drag • Electronics

cooling Plastics • Mould Flow

FEA Analysis • Static • Vibration • Shock • Fatigue & Creep • Drop test • Non linear • Thermal

• 2D/3D- Drawings & engineering

• Product development • Design vetting • Rendering • Event depiction through

animation

SUMMARY OF SERVICES OFFERED

SOME OF OUR CLIENTS

13

Ten glorious years of service to industry & customers

Conceptia Software Technologies Private Limited #22, 2nd floor, 100 feet ring road, 6th block. 3rd phase, BSK 3rd stage, Bangalore-560085 www.conceptia.in, Email : services@conceptia.in Ph. +91 8026799382

HEAD OFFICE SINGAPORE - SUBSIDIARY OFFICE

CONCEPTIA SOFTWARE TECHNOLOGIES PVT. LTD. #22, 6TH BLOCK, 3RD PHASE, BANASHANKARI 3RD STAGE,

BANGALORE – 560 085, INDIA. PH: +91-80-26799382

services@conceptia.in

CONCEPTIA ASIA PACIFIC PTE. LTD. 10 ANSON ROAD # 05-17 INTERNATIONAL PLAZA

SINGAPORE – 079 903 bd@conceptia.in

COCHIN - BRANCH OFFICE SHARJAH - BRANCH OFFICE

BUILDING NO. XXIV/40 A, FIRST FLOOR COCHIN UNIVERSITY ROAD, SOUTH KALAMASSERY, COCHIN- 682002, KERALA, INDIA

Services@conceptia.in

E-LOB OFFICE # E-80G -19

PO BOX 50590, HAMRIYAH FREE ZONE SHARJAH, UNITED ARAB EMIRATES.

bd@conceptia.in

OUR OFFICES

14