Post on 07-Aug-2015
description
Share |
#2
Mar 23, 2009, 11:09 PM
Ask Remember Me?
Browse Ask Answer Search Join/Login
Join Our CommunityHome ▸ Home & Garden ▸ Home Electronics » What is DB gain?
What is DB gain?
Asked Mar 23, 2009, 08:24 PM — 4 AnswersWhat is DB gain when associated with home theatre speaker volumes? Each speakers volume is set with DB gainstarting at 0 with settings - and + from 0. I have no idea what it represents.
Search this Thread
4 Answers
DanielF Posts: 158, Reputation: 65
Junior Member
The quick answer to your question is "It doesn't really matter!". It's just a number that represents a change in volume.
But I'll give you the 'full' answer now, in case you're really interested (skip to the last paragraph if you're not!)...
The decibel (dB) is a logarithmic expression of a ratio of two values. It is used in electronics and sound engineering to
express the ratio between two voltages, or two currents, or two powers, or two sound pressure levels (SPL). Being
logarithmic, small numbers can be used to express huge ratios.
The decibel value is calculated from a ratio of two voltages or currents as follows:
20 * log10(V2 / V1)
While for a ratio of two powers or SPLs, it is:
10 * log10(P2 / P1)
[The * means 'multiplied by', the / means 'divided by', log10 means 'logarithm to base 10' (of the value in brackets).]
By way of examples, here are a few dB values and the power ratios they represent:
DBRatio (n:1)
01.0
11.26
32.0
1010
20100
-10.79
-100.1
(Sorry about the ugly dots separating columns; I haven't learned how to do a table in HTML.)
So if you adjust a speaker level by +1dB, you have increased its power by a factor of 1.26 relative to the 'reference'
level (whatever that is, and it doesn't matter in the case of a home theatre setup). If you adjust it by -1dB, the power is
reduced to 0.79 of the reference level.
By way of guidelines, a 1dB (plus or minus, doesn't matter) change in power gives an only-just audible perceived
What is DB gain? - Ask Me Help Desk http://www.askmehelpdesk.com/home-electronics/what-db-gain-333012...
1 of 4 17-Jan-13 10:51 PM
Reply
#3
Mar 23, 2009, 11:18 PM
Reply
#4
Mar 23, 2009, 11:18 PM
volume difference. 3dB is a quite noticeable difference, and 10dB is approximately a doubling/halving of perceived
volume. So just adjust each speaker's level in 1dB steps until all four/five sound the same volume, using the white noise
test tone provided (with the 'master' volume control set to your 'normal' listening volume). Of course one speaker will be
left at 0db (no change) while the others are adjusted up or down to match volume, if required.
Hope I haven't just confused you. Like I said at the beginning, you don't need to understand what dB means to make
the volume (level) adjustments, it being obvious that a + adjustment is higher volume, and - is lower. The aim is to have
all speakers sounding equally loud with the test tone, when sitting at the listening position (and there can be only one
'correct' listening position - the user guide will show you where that is in relation to the speakers).
Daniel
Helpful
KISS Posts: 12,593, Reputation: 4378
Uber Member
Here is a power point presentation on loudness. A little tough to muster. There should be a free powerpont reader on
Microsoft Corporation.
Physics, Physiology and Psychology of Loudness
What I can tell you is that db is always based on a reference level and sound is logarithmic. The formula for power
using db and two signal levels is different than if we were using two voltages.
This should explain things a little better.
dB: What is a decibel?
I THINK that a 3 db change results in twice as loud or a 10 fold increase in power.
The point is, the gain of an amp (some multiplier) say 2, does not mean it 2 times louder. The db levels should translate
into a perceived loudness relative to the maximum output which has the reference level of 0 db.
-infinity is no sound. That's why the numbers go negative.
Loudness is a complex subject. There are weighting curves. Sometimes 0 db is the threshold of human hearing. Now
you can describe the absolute sound level of a jackhammer or an airplane.
Signal to noise ratio is also expressed in dm.
ANtenna gain is also in db. Losses in transmission lines are in db. Using db cuts out a lot of multiplication or division.
Helpful
KISS Posts: 12,593, Reputation: 4378
Uber Member
Here is a power point presentation on loudness. A little tough to muster. There should be a free powerpont reader on
Microsoft Corporation.
Physics, Physiology and Psychology of Loudness
What I can tell you is that db is always based on a reference level and sound is logarithmic. The formula for power
using db and two signal levels is different than if we were using two voltages.
This should explain things a little better.
What is DB gain? - Ask Me Help Desk http://www.askmehelpdesk.com/home-electronics/what-db-gain-333012...
2 of 4 17-Jan-13 10:51 PM
Reply
#5
Dec 21, 2011, 09:02 AM
Reply
dB: What is a decibel?
I THINK that a 3 db change results in twice as loud or a 10 fold increase in power.
The point is, the gain of an amp (some multiplier) say 2, does not mean it 2 times louder. The db levels should translate
into a perceived loudness relative to the maximum output which has the reference level of 0 db.
-infinity is no sound. That's why the numbers go negative.
Loudness is a complex subject. There are weighting curves. Sometimes 0 db is the threshold of human hearing. Now
you can describe the absolute sound level of a jackhammer or an airplane.
Signal to noise ratio is also expressed in dm.
ANtenna gain is also in db. Losses in transmission lines are in db. Using db cuts out a lot of multiplication or division.
Helpful
nirupa Posts: 1, Reputation: 10
Junior Member
it is a measure to calculate the output to input ratio of a signal in an electrical system.it is represented by
gain in dB=10*log(Vo/Vi)
where Vo=output voltage
Vi=input voltage
Helpful
Not your question? Ask your question View similar questions
Add your answer here.
Fonts
Notification Type:
What is DB gain? - Ask Me Help Desk http://www.askmehelpdesk.com/home-electronics/what-db-gain-333012...
3 of 4 17-Jan-13 10:51 PM
Check out some similar questions!
I need to gain weight 2! [ 5 Answers ]
I'm 17 nealy 18, and can't seem to get past 7st 4lb, its like my maximum. Its been like this for a few years. What can I do? I'm about to get in to
modelling and have been to the doctors. Help!
I need to gain [ 1 Answers ]
I have looked over some of the answers that have been given and still have not found an answer! Here is my probley. I'm 25 almost 26 I'm
5foot 6 and I have weight 120 pounds for the last 3 years and I have 3 kids and I just want to gain 15 pounds to kind of fill my self out I'm
active but I eat 3...
Security deposit to gain or not to gain? [ 1 Answers ]
Living in Rochester NY. Had a one year lease ready to move . This complex is privately owned corp. Its huge. Leaving Rochester office claims
it will send security in one month time. Does this complex have the right to keep the interest my security deposit has gained. In the past living
at other...
I need to gain some weight! [ 6 Answers ]
I am way to skinny. I'm 19 and I still only way 100 pounds! Its get me frustrated when I see other girls who acutally have butts and curves...I
don't no what to do anymore I eat so much but it just doesn't help..I really need help because this is creating no self of steem and I don't even
want to...
Weight gain/s [ 1 Answers ]
After quitting 20 yeasrs of smoking I have gained weight by 1 stone. What is the correct weight for being 5 foot 1, age 35? What calorie
instake can I have? I have never looked at the back of packets of food/gained weight like this before. What tummy excersises can be
compledted at home? ...
View more Home Electronics questions Search
EN NL ES Home Blog Contact Us Privacy Policy Experts Help
What is DB gain? - Ask Me Help Desk http://www.askmehelpdesk.com/home-electronics/what-db-gain-333012...
4 of 4 17-Jan-13 10:51 PM