Post on 06-Mar-2020
Engine Service Tool Kit BMW
Instructions
www.lasertools.co.uk
The BMW N42 and N46 1.8 and 2.0 twin cam petrol engines feature Vanos variable camshaft timing units on the inlet and exhaust camshafts combined with the BMW Valvetronic system which varies the timing and lift of the inlet valves.
5711
Distributed by The Tool Connection Ltd
Kineton Road, Southam, Warwickshire CV47 0DRT +44 (0) 1926 815000 F +44 (0) 1926 815888info@toolconnection.co.uk www.toolconnection.co.uk
If this product fails through faulty materials or workmanship, contact our service department direct on: +44 (0) 1926 818186. Normal wear and tear are excluded as are consumable items and abuse.
Guarantee
• Wear suitable eye protection.
• Maintain the tools in good and clean condition and always return to case for safekeeping.
• DO NOT use tool if damaged or worn.
Precautions
2 3
www.lasertools.co.uk www.lasertools.co.uk
Engine Service Tool Kit - BMW
Applications
Important
This kit (5711) is used for removal, installation plus dismantling and rebuilding the camshaft carrier bracket | Valvetronic assembly. It is used in conjunction with the Engine Timing Tool Set 4419, which includes tools necessary for timing the engine when, for example, changing the cam chain or camshafts.
BMW: 1.8 | 2.0 engines | N42 | N46 | N46t (B18b | B18 | B20 | B20a | B20b)118i, E87 | 120i, E87 | 316i, E46 | 316ti, E46, 318i, E46 | 318ti, E46 | 318i, E90 | 320i, E90 | 520i, E60 | Z4,2.0 E85 | X3.2i, E83
You must refer to the manufacturer’s service instructions or documentation to establish the correct procedures for using this equipment.
The following notes and diagrams are provided as a guide only. No liability is accepted for incorrect use of this product.
Contents
Camshaft carrier mounting fixture assembly
Assemble the four support struts D to the fixture plate C. They are secured by hex headed set screws (4mm). Take care to assemble the short support strut in the correct position (refer to diagram). The short strut has a raised lip on its base which corresponds to a recess in the fixture plate.
The mounting fixture assembly is designed to be mounted on a vice (refer to diagram).
Camshaft securing tool (front) Camshaft securing tool (rear)
(Refer to the manufacturer’s service instructions or documentation to establish the correct procedures for using this equipment.)
(Refer to the manufacturer’s service instructions or documentation to establish the correct procedures for using this equipment.)
Ref Oem Code DescriptionA 11 9 310 Intermediate lever clamp set (X 8)B 11 9 301 Inlet camshaft securing tool (rear)C 11 9 320 Camshaft carrier mounting fixtureD 11 9 320 Camshaft carrier mounting support struts
E 11 9 302 | 11 9 303 Inlet camshaft securing tool (front)F 11 9 390 (Handles application) Torsion spring remover | installer
AB
C
D
E
F
BE
Intermediate Lever Clamps Torsion spring remover / installer
A F