éa

&@§qtskffi

ffiTECHNICAL ENGLISHMW1

STARTING SYSTEM

UNIT 1É

STARTER ( Part lV )

A.- ASSEMBLY

Upon assembling, always coat the sliding surface or moving portion c':-:armature shaft splines, starter clutch bushing, end frame bushings, drive lever a..'.-.moving stud with multipurpose grease.

1.- Assemble the clutch assembly (2) onto the armature (1).

2.- After installing the clutch stop collar (3) and the snap ring (4) on:: -:armature shaft, lock the snap ring by calking the collar at two places. =

=

2e).

4

7.

B,

L

1(34ttHo

#fi#rllZ,

11

12

Fig. 29.- lnstalling Starter Clutch

3.- Assemble the drive lever (2) onto the clutch (1) as follows.)

a.- Always install the drive lever as shown in the illustration. If the i

is incorrect, the pinion meshing with the ring gear will be improper.

b.- Always install the steel washer (3) towards the clutch side.

HLECTRICI DAN AUTO [VlCITRIZ

¡

ELffiCTR