d
1
é a &@§ qtskffi ffi TECHNICAL ENGLISH M W1 STARTING SYSTEM UNIT 1É STARTER ( Part lV ) A.- ASSEMBLY Upon assembling, always coat the sliding surface or moving portion c':-: armature shaft splines, starter clutch bushing, end frame bushings, drive lever a..'.-. moving stud with multipurpose grease. 1.- Assemble the clutch assembly (2) onto the armature (1). 2.- After installing the clutch stop collar (3) and the snap ring (4) on:: -: armature shaft, lock the snap ring by calking the collar at two places. = = 2e). 4 7. B, L 1( 34 tt Ho #fi# rl lZ, 11 12 Fig. 29.- lnstalling Starter Clutch 3.- Assemble the drive lever (2) onto the clutch (1) as follows.) a.- Always install the drive lever as shown in the illustration. If the i is incorrect, the pinion meshing with the ring gear will be improper. b.- Always install the steel washer (3) towards the clutch side. HLECTRICI DAN AUTO [VlCITRIZ ¡ ELffiCTR
-
Upload
dante-flores -
Category
Documents
-
view
215 -
download
2
Transcript of d
éa
&@§qtskffi
ffiTECHNICAL ENGLISHMW1
STARTING SYSTEM
UNIT 1É
STARTER ( Part lV )
A.- ASSEMBLY
Upon assembling, always coat the sliding surface or moving portion c':-:armature shaft splines, starter clutch bushing, end frame bushings, drive lever a..'.-.moving stud with multipurpose grease.
1.- Assemble the clutch assembly (2) onto the armature (1).
2.- After installing the clutch stop collar (3) and the snap ring (4) on:: -:armature shaft, lock the snap ring by calking the collar at two places. =
=
2e).
4
7.
B,
L
1(34ttHo
#fi#rllZ,
11
12
Fig. 29.- lnstalling Starter Clutch
3.- Assemble the drive lever (2) onto the clutch (1) as follows.)
a.- Always install the drive lever as shown in the illustration. If the i
is incorrect, the pinion meshing with the ring gear will be improper.
b.- Always install the steel washer (3) towards the clutch side.
HLECTRICI DAN AUTO [VlCITRIZ
¡
ELffiCTR
