BEECO ACV PRESENTATION

Main Applications

Level Control Pressure Control Pump Control

Flow Control Safety ValvesElectronic Control

LADWP Project

What are Beeco’s ACV main differentiators?– Better Performance:

• Better pressure control at very low flows and at very high flows. Larger flow range.

– Lower Cost of Ownership:• Reliability – Better materials being used as standard.• Maintainability – Simpler structure than competitors.• Shelf Life – More resistance to cavitation, where others fail.

– Wider Control Solutions Range– Extensive Support:

• Design phase: consultation in control application selection and valve type selection

• After sale support

a

b > a

b

Small diam.By-Pass

V-Port(V or U shape)

Reduced Port

Performance: Stable regulation at low flows

Our competitors use inferior solutions at low flows:

Beeco uses a patented and superior solution for low flow regulation which:– Does not requires by-pass – Does not affect the valve when fully open (like V-port)

Beeco ACV Low-Flow stability solution:

Low pressure-losses when fully open

FULLY OPEN REGULATING

Able to regulate at near zero flow rate.

• No need for V-Port

• No need for by-pass

These two valves can regulate the same low flow!

Performance: Cavitation Index

Low cavitation index will enable safe operation under high pressure differential and low operation noise.

Beeco ACV valves were tested for cavitation by the hydraulic laboratory of Utah State university.

Low Cost of Ownership:– Easy maintenance and service

(trim is pulled upwards)– Low weight internal trim– No need for special tooling– No periodic parts replacement, greasing etc.– Self-flushing control filter– Same standard valve used for low and high flow– Standard internal SST internal trim (up to 200mm)– No preventive maintenance (just periodic inspection at long

intervals)

Long term operation with minimal operational costs!

Hyd. Control Solutions

Control Solutions:– A full range of hydraulic control solutions using a wide variety

of control devices– Pressure Control applications– Flow control application– Water level control solutions– Safety and protection devices for water-supply systems,

pumping systems etc.– Water hammer\Surge prevention & attenuation– Automated & Remote control of the hydraulic parameters

Support

Pre-Sale Support:

Design phase assistance in:

– Hydraulic control solution selection

– Supplying computerized, Water-Hammer\Surge analysis

– Tailoring the solution to the specific requirements

Enquiry (end customer or engineer/designer)

Intake, Questionnaire, Gathering of Information

Technical Considerations,Data Calculations,

Software Simulation

Solution Specification & Draft Layout

Provision of Valve Solution

Support

Additional Support:– Training programs– Technical back-up – One stop shop for a wide variety of supplementary

devices