Post on 01-Jul-2015
description
Electricity
6D: Monday 6th December
Experiment
• Alter variable resistor and take readings of terminal voltage, V, and current, I
• Plot V versus I
rE
V
A
V
I
the e.m.f.
the gradient = - internal resistance
Short circuit current
• The greater the current, the more energy will be dissipated in the
power supply until eventually all the available energy (e.m.f.) is
wasted and none is available outside the power supply. This
maximum current is the short circuit current – the current which
would flow if the terminals were connected with a short piece of
thick wire (zero resistance: R=0).
• I short circuit = e.m.f / internal resistance = E/r
Purple Book, page 51
• Exercise 4.5: E.M.F. and Internal Resistance, Questions 1 11
Wheatstone bridge circuit
• Wheatstone bridge consists of 4 resistors:
V
R3
R4
R1
R2
A B
If VOA = VOB there is no p.d. between A and B so no current flows.The potentials at A and B depend on the ratioof the resistors that make up each of the two voltage dividers.The voltmeter forms a ‘bridge’ between the two voltage dividers to make up a bridge circuit.The bridge is said to be balanced when the resistors in the two potential dividers are in the same ratio as each other and voltmeter reads zero:
O
Finding an unknown resistance
• Circuit is set up with three resistors of known values – one needs to be a variable resistor
• The unknown resistor is connected into circuit as fourth resistor• Variable resistor is adjusted until the voltmeter reads zero, i.e. the
bridge is balanced• Substitute known values into equation to calculate unknown
resistance
• Note: Balance condition does not depend on supply voltage• The meter must be sensitive to detect zero precisely• Circuit is sometimes drawn in a diamond shape or rotated through
90 degrees
Wheatstone bridge – slightly out of balance
• When one of the resistors is varied slightly above and below its balance value, the voltmeter shows a reading which is directly proportional to the change in resistance
• This direct proportionality (or linear) relationship allows Wheatstone bridge to be used as as type of measuring device when operated near to its balance point
Out of balance voltage
Out of balance resistance
+
+
-
-
0
Purple Book, page 53
• Exercise 4.5: Wheatstone Bridges, Questions 1 3