Post on 21-Jan-2016
1
XAS 375 JD6 Compressors
Scott Malm
Committed tosustainable productivity.
2
Product Data - XAS 375 JD6
Settings/Shutdowns - XAS 375 JD6
4
AIR SYSTEM INLET VALVE
Spring loaded in the open position
Control Air closes the inlet
Also serves as check valve
Unloading valve
Regulating valve Regulating valve
Load solenoid
Min Press valve
Unloading valve
Load solenoid
Min Press valve
No Load/ Starting Load
Regulating valve Regulating valveUnloading valveUnloading valve
Min Press valve Load solenoid Min Press valve Load solenoid
Unload Blow Down
9
REGULATING SYSTEM REG VALVE
Spring loaded
Adjusting receiver pressureby changing spring tension
• to pressure gauge and loading valve
• to speed regulator• to unloading valve
Regulating pressure:
Receiver pressure
The air receiver pressure can be set to another value by adjusting the spring tension of the regulating valve. This is done by turning the handle on top the valve. Increasing the spring tension, by turning in, will increase the regulating pressure and consequently the pressure inside the vessel. Turning out will decrease the pressure.
In order to regulate the pressure inside the reciever tank of our compressor, the air intake and the engine speed have to be controlled. This is done pneumatically. For that reason, we need regulating pressure. The regulating valve reduces the pressure inside the tank, thus providing the regulating pressure. This regulating pressure is then supplied to the unloader valve and the speed regulator or RPS.
10
Maintains a minimum pressure
of 58 PSI for oil flow
Also contains the final check
valve
AIR SYSTEM MIN PRESS VALVE
Control Panel
Load Solenoid Valve – 1089 9515 02
Maintenance – XAS 375 JD6
14
XC 2002 Controllers
15
XC2002 Controller - XAS 375 JD
16
XC2002 Control Module
Display
Fuel Level
Engine Coolant Temperature
Engine Oil Pressure
Engine RPM
Battery Voltage
Service Timers
Engine Inlet Air Temperature
Fuel Consumption (L/H)
Engine Fuel Temperature
Regulating Pressure
Log List – Will Hold last 30 Historic Codes
Alarm List – Shows Active Alarms Only
Parameters – Choose Another Language, Reset Service Timers, Change Measuring Units, etc…
Control Module – 1604 9516 01
XC2002 Controller
John Deere codes will display here
XC2002 Controller
XC2002 Controller
XC2002 Controller – * Unit Type 2
J1939 Canbus Communication
J1939 Canbus Communication . Cont…
John Deere Engine Fault Code List
John Deere Engine Fault Code List
John Deere Engine Fault Code List
John Deere Engine Fault Code List
John Deere Engine Fault Code List
John Deere Engine Fault Code List
John Deere Engine Fault Code List
John Deere Engine Fault Code List
John Deere Engine Fault Code List
Displaying of J1939 DM1 Alarms
34
Electrical System
35
Legend
Detailed Electrical Diagram
36
37
John Deere – Tier III – RPS in place of Pneumatic Speed Regulator
Regulating Pressure Sensor
“Speed Sensor”
38
*Preheat Relay K1 Controlled by JDEC
Starter RelayPreheat Relay
K1 – Preheat Relay – JDEC Warning
Troubleshooting - Information
40
41
Troubleshooting - Information
42
Troubleshooting - Information
43
Preventive Maintenance Filter Kits – XAS 375 JD6
Spare Parts Recommendation
Committed tosustainable productivity.