Stepping motors
Jari Kostamo
Outline
• Introduction• Stepping motor structures• Properties of stepping motor• Control of stepping motors
Stepping motor
• Stepping motor is an electromechanical device which converts electrical pulses to discrete mechanical translation.
• Axle of the stepping motor turns in discrete steps when the coils are pulsed with electric current in proper sequence
• Direction of rotation depends on the sequence of the pulses
• Angle of rotation is determined by the number of pulses • Rotation speed is determined by the frequency of the
pulses
Stepping motor
• Typically for small power applications (holding torque in a range of 1 – 1000 Ncm or power less than 750 W)
• Low cost• Easy to interface with digital control with microcontrollers. • Precise control without feedback (step angle as low as 0,5o)• Can be used with feedback• Stepping rated possible up to 40 kHz (drive) or 3 kHz (pull in freq)• Dynamical properties are only moderate due to the operating principle• Can lose steps when loaded heavily • Operating range may contain problematic areas• Achieved position is not perfectly precise but the motor can be displaced
with a small torque. • Operating is slightly shaking• Audible noise due to the stepping
Stepping motors
• Typically 12, 24, 72, 100, 144, 180 or 200 steps per revolution (equal to 30, 15, 5, 3.6, 2.5, 2 or 1.8 degree step angle).
• With microstepping even 10000 steps per revolution can be achieved.
• Unipolar and bipolar motors.• Open control is used if losing steps
does not cause critical problems.
Magnetic circuit
• Translation in stepping motor is produced by magnetic forces
• Magnetic circuit is generated with coils
• Magnetic field strength depends on the nuber of ampere turns, current and geometry
• Inductance of the coil creates an opposing voltage proportional to the rate of change in current.
– Inductance has a tendency to limit the chages in current.
• Larger voltages are needed if rapid changes are desired.
Current control
Pulse width modulated control (PWM)
• Efficient and modern way to control currents of the motor coils is PWM– PWM amplifier, chopper, switched
mode amplifier...
• Transistors are rapidly switched on and off
• ON-state has low resistance – OFF state has high resistance – Yields to small losses
• Current is defined by the proportion of the ON and OFF states
• Can be implemented with uC
• Dedicated circuits available.
Permanent magnet motor Reluctance motor Hybrid motor
Stepping motors
Kenjo, T., Stepping motors and their microprocessor controls
Variable reluctance stepping motor; VR motor
Kenjo, T., Stepping motors and their microprocessor controls
Permanent magnet stepping motor; PM motor
Kenjo, T., Stepping motors and their microprocessor controls
Hybrid stepping motor
Linear stepping motor
2D stage: Baldor
Parker
• Functional principle similar to hybrid motor,
2D motions possible
(Kirjasta Bolton, Mechatronics)
Full stepping
Half stepping
A1 A2 B1 B2
A1 A2 B1 B2
Stepping motor control example
Half stepping
(Book: Fraser & Milne, Integrated Electrical and Electronic Engineering)
Kenjo, T., Stepping motors and their micro-processor controls
Dynamical properties of stepping motors
Kenjo, T., Stepping motors and their micro-processor controls
Holding torque
Kenjo, T., Stepping motors and their micro-processor controls
“If vibration at low speeds is an issue, consider the geared types. Not only does changing gears increase torque, but also these models improve starting and stopping responsiveness.”
Settling time
Lawrence & Mauch, Real-TimeMicrocomputer System Design
Speed-torque graph
Resonance frequencies
Typical stepping profile
Stepping rate
Direct computer
control
Computer control withintelligent indexer
Computer control with stepping circuit
Lawrence & Mauch, Real-TimeMicrocomputer System Design
Control systems for stepping motors
Digital linear actuator
Top Related