Download - jetting · Jetting is a surface appearance defect caused during cavity filling. It is also called jet marks or worm tracks. ... plastic at the surface of the part. Injection Molded

Transcript
Page 1: jetting · Jetting is a surface appearance defect caused during cavity filling. It is also called jet marks or worm tracks. ... plastic at the surface of the part. Injection Molded

Page 37

Jetting

Notes Jetting

I. Example of Jetting

Jetting

Jetting is a surface appearance defect caused during cavity filling. It isalso called jet marks or worm tracks.

II. How the Problem Develops

Jetting occurs during mold filling when plastic squirts or jets through thegate and on into the cavity without hitting any obstruction. Eventually,the plastic forms a flow front and the cavity is filled. But in themeantime, the surface of the jet of plastic has cooled slightly, and someof it is pushed to the surface. The appearance defect is the jet of chilledplastic at the surface of the part.

Page 2: jetting · Jetting is a surface appearance defect caused during cavity filling. It is also called jet marks or worm tracks. ... plastic at the surface of the part. Injection Molded

Injection Molded Part Problems & Solutions Study Guide

Notes

Page 38

What we want to happen during the start of filling, is a flow front to format the gate and the cavity to fill as an unbroken flow front.

III. Cause of Jetting

A. Unrestricted flow through the gate at the beginning of cavity filling.

IV. General Solution to Jetting

A. Restrict the initial plastic flow into each cavity.

V. Mold and Part Design Solutions

A. Gate placement:

1. Gates should be placed so that the plastic entering the cavity hits anobstruction. This will stop the jet from forming.

a. The obstruction can be a wall, a pin, or any interference that willstop the jet.

B. Gate thickness:

1. A gate thickness of one half to two thirds the wall thickness will usuallystop any jetting.

Page 3: jetting · Jetting is a surface appearance defect caused during cavity filling. It is also called jet marks or worm tracks. ... plastic at the surface of the part. Injection Molded

Page 39

Jetting

Notes Gate Thickness

Plastic leaving a gate will typically expand to about twice the gatethickness. If this expansion is enough so that the plastic touches bothwalls of the cavity, the jet will be stopped and a flow front will form.

VI. Operating Solutions

Problem Analysis

A. Reduce plastic flow rate - A jetting problem is caused by a high plasticflow rate when the plastic first enters the cavity.

1. Reduce the initial fill rate (on machines with programmed injection).

T

2T

Gate size 1/2 to 2/3 thecavity wall thickness

plasticmelttemperature

plastic flow rate

Jetting