Installation guide for 2010 2011 Mazda 3
gps navigation with 3G WifiHave you installed a dvd player for your 2010 2011 Mazda 3?
Maybe you will say that all things for installation can be solved by
professional technicians.However,its very possible for you to
achieve it yourself with installation guide for 2010 2011 Mazda 3
gps navigation with 3G Wifi.But to avoid damage or
accident,please do not disassemble the unit privately.
Before removal,you can start the radio to check whether the
dashboard function display and button operation is normal;the
surface of car inside and outside whether have any unnormal
phenomenon.If everything is ok,then you can begin your action
about car radio.
To be honest,modern dvd player can bring you too much
entertainments and convenience.So what specific process is? Dont
worry,this article will tell you how to upgrade the head unit of your
car.
1.Pry and remove air vent with a plastic scraper or panel removal
tool to avoid damaging the plastic
2.Put air vent in front place and first remove two screws holding
the radio in place
3.Next slide one finger down each side behind the panel,pull the
radio forward and up to remove it
4.Disconnect the grey antenna connector(a screw will help unlock
it)
5.Disconnect the stock AUX input connector
6.Flip the stock radio over so you can see the locking tab on the
main connector,then disconnect the main connector
7.Here is the empty radio bay,ready for your new unit
8.Connect the eonon wiring harness,one by one:aux input
cable,canbus adapter,antenna adapter,main connector
9.Install the GPS antenna:this location just under the dash behind
vents gets excellent reception and does not require any visible
wiring
10.Remove the DVD lock-down screws
11.USB and Ipod/Ipad cables:one location for these is in the glove
compartment,one 3/4 hole will allow all three cables to pass;use a
3/4 wood-boring bit,and drill carefully so the drill does not go
through any farther than necessary
12.Insert the USB cables from the radio side,insert the Ipod cable
from the glove compartment
And final connections and fit
13.Connect the remaining cables:
GPS and WIFI antenna(gold)
IPod/iPad cable(black)
Aux L/R(red/white)
Main Harness(black)
14.Tidy the cables up and slide the radio into position
15.Place the WIFI antenna to the left of the GPS antenna,in front of
the instrument cluster.Route the cables so they come down
between the two ventilation openings as shown.Extra cable may be
cliled,tied,and stowed deeper into the cavity behind the vents
16.Re-connect the car battery and power up the radio to make sure
it works.With the radio on,test the steering wheel buttons as well
17.Install the two screws that secure the radio in the dash
18.Finally,check that all of the wires are still in place,and re-install
the ventilation panel
19.New unit after upgrade, stereo autoradio with gps bluetooth 3G
Wifi of 2010 2011 Mazda 3
This is all operations for Mazda 3 gps sat navi system
installation.And here are some warm prompt:
1.Do not wash the unit with strong chemicals,cleaning agents,or
strong detergent
2.If you will wipe the screen ,youd better use a clean soft fabric
to,not ordinary fabric
3.Please dont use other sharp objects but the touch screen pen to
operation unit, ,or it will damage to the screen
For more information about car dvd,you can visit the following
website: http://www.seicane.com/8-inch-in-car-gps-navigation-stereo-
replacement-for-2010-2011-mazda-3-with-3d-map-cd-dvd-player-
bluetooth-music-mp3-tv-tuner-3g-wifi-aux-1080p-dvr-pop-hd-video-c034.
Top Related