How to Sew a Button
Step by Step Instructions
Thread the Needle
For buttons, you should double the thread to make the job quicker. Pull it through the needle so that there is an equal length of thread extending from both sides.
Why might a double thread be better than a single thread?
Tie a knot at the end of the thread.
One way to tie a knot is to wrap the thread around your finger as shown and pull the end through the loop. Leave a tail of thread.
Why do we need a knot?
Position the button.
Line the button up with the other buttons on the garment if
you’re replacing a button, or with your
marking if it is a new garment.
What are some ways you might know where to put the button?
Push the needle through
Push the threaded needle up through the fabric and through one hole in the button. Pull the thread all the way through on each stitch.
What might happen if you don’t pull the thread all the waythrough each time?
Place a pin under the center of the button
Place and hold a pin under the center of the button. When the pin is taken out, it will create a "shank" so that there will be space between behind the button for the material that will need to go there when the garment is buttoned.
Why do you think it is important tohave a “shank” on the button?
Button with stitching in an X.
On a 4-hole button choose the one diagonal to the first hole if you want the threads to cross in an "X" formation.
Why would someone choose to sew their buttonon in an “x”?
Button with parallel thread pattern
If you want two parallel lines of
thread showing, choose the next
hole that is opposite the first
Why might someone choose this way to sew on a button?
Push the needle through the next hole
Still holding the pin in place, pull the thread all the way through. Once that is done, the pin will be kept in place by the thread. Hold the button in place so it does not move.
Why are you using the pin during this process?
Repeat the sewing process
Repeat the sewing process 4-6 times to make sure the button is securely in place. On 4-hole buttons, make sure that the stitches have been made evenly, so that all four holes are equally used.
Why would you sew through the button more than once?
Come up between the fabric and the button.
On the last stitch, push the needle through
the material, but not through a hole
in the button.
How do you know when it’s the last stitch?
Wrap the thread around the "shank".
Wrap the thread 4 times around the thread between the button and the material to reinforce the shank you have created.
How does this help the button stay on better?
Go between the button and material
Pull the thread out into the area between button and material, remove the pin and pull up the button a little.
What is this area (between the button & fabric) called?
Back down through the material
Push the needle back down through the material.
Why would we want to knot it on the insiderather than the outside?
Back stitch to tie off the thread
Make 2-3 knots to secure the thread– Pull the needle under
the stiches already made
– Pull the thread through the loop you made and pull tight
– Repeat
Why are we knotting more than once?
Cut off the excess
Trim the excess thread
Why do we trim the thread? Why do we trim it last?Why shouldn’t you trim with teeth?
References
http://www.wikihow.com/Sew-a-Button Video Clips http://www.youtube.com/watch?
v=Gg0pfdIRBgw http://www.youtube.com/watch?
v=hrSs_DiJ-ZA [[Image:Sew_button_1.jpg|thumb|
description]]
Top Related