F13-FSAE DESIGN REVIEW
Nick Twombly Nathaniel Tyler
Michael HaeuberNg Kay Chong
Matthew HaeuberBrian WattersAzim Nasser
Description of Sub-Systems Chassis Upright Front Suspension Rear Suspension Control Arms Brake Rotors Braking System
Chassis Reduce required materials Maintain Torsional Rigidity Simplify manufacture
requirements Meet class requirements FEA analysis Driver ergonomics
Upright Design House the bearing assembly Mounting point for the steering and
suspension connections, as well as the brake rotors
Simplify manufacturing requirements Minimize deflection under turning, braking
and accelerating Provisions for camber adjustment Possible provisions for caster adjustment
Front Suspension The front suspension design will follow a
non-parallel short-long arm style. This means that the upper control arm will be shorter than the lower control arm. This will allow for more contact of the tire to the road when the car goes into a corner. The spring and damper will be connected from the chassis to the lower control arm.
Front Suspension ContinuedExisting Design Vs Proposed Design
Rear Suspension The rear suspension design will consist
of either a solid live axle system or a system similar to the front suspension. A decision will be made on which design to use based on the outcome of the design review.
Continued (Solid live axle) The solid live axle will consist of a
bearing carrier which will house the bearing as well as the axle.
Control Arms For the control arms there are certain
forces that need to be considered when you are stationary versus when you are dynamic. When stationary the force of gravity is the only important force. When you are dynamic, bump forces, internal forces and centrifugal forces need to be considered.
Brake Rotors
Brake Rotors Continued The brake rotor consists of combination
design of slotted, cross-drilled and ventilated design.
The material will be used is maraging steel.
Braking System For brake system design, the FSAE
brake system principal, the dimension A should be 3 times longer than dimension B. If 150 N force is applied into the brake pedal of ratio 4:1, 600N force will be obtained. This means driver do not have to use plenty of energy to apply the brakes.
Top Related