Expandable Wall-Mounted Organizer
MOUNTING INSTRUCTIONS
AMounting
Plate
FCamLock™ Holders x4
G Hooks x4
BAluminum
Rail
HScrews x4
IDrywall
Anchors x4
DInner Rail
Endcap
EOuter Rail
Endcap
CSupport
Plate
INCLUDES
1”
1”
1”
Determine a location for the organizer. Pleasenote that the aluminum rail (B) extends past the mounting plate (A) so adequate clearance isnecessary.
B
A
Mark hole on the left side of mounting plate (A).Level mounting plate using built-in level and markhole on the right side of mounting plate (A).
1
A
If not mounting directly into a stud, use drywall anchors (I). TIP: Put a starter hole in the wall for anchor to go in easily.
DRYWALL OPTION
Ix2
Line up mounting plate (A) with pencil marks. Arrows on mounting plate should be in up position. Fasten the mounting securely to wall using screws (H) provided.
2
H
A
H
A
1
1
2
2
Attach aluminum rail (B) to mounting plate (A) by hooking from top and pushing until it clicks in place.
3
B
A
2” min
Slide outer rail (B) to desired length. Be sure to maintain a minimum 2" overlap between the inner and outer rails. Mark location on wall.
B
4
OVER
Fasten support plate (C) to mounting surface using screws (H) provided. Slide aluminum rail (B) back into place.
6
C
B
H1”
Slide outer rail (B) back and insert support plate (C) into outer rail (B). Support plate (C) must be installed at least 1" from desired length.
C
B
B
5
If not mounting directly into a stud, use drywall anchors (I). TIP: Put a starter hole in the wallfor anchor to go in easily.
DRYWALL OPTION
B
I
Slide CamLock™ holders (F) onto aluminum rail (B).
7
Side View
F x4
B
1
2
Hooks (G) attach from top of rail and snap intoplace.
8
x4 G
Insert endcaps (D & E).
9
D
E
1
2
Lift hooks (G) from bottom to remove or adjust their positions. Note: Camlock™ holders (F) can only be removed by sliding them off of the rails.
REMOVING/ADJUSTING HOOKS
G
www.oxo.com
Top Related