DRAFT
IntroductionMechanical Power• Reciprocating Engines•Turbines Turbines are compact machines (high power to weight ratio, having less balancing problems and less oil consumption.
Turbines•Hydraulic turbines•Steam turbines•Gas turbines The performance of these machines depend on compressor efficiency, pressure ratio and turbine inlet temperature.
Introduction Gas Turbine versus Steam turbine• Steam turbine plants are utilized for producing large power
1000 MW per unit. Gases are used to heat water and steam. Then steam is used in turbines to produce power.
• In gas turbines gas is directly used to produce power• Power cycles are simple, complex and combined (steam and
gas)• Simple and combined gas turbines Use of turbines• Electrical power generation• Jet propulsion• Supply of compressed air/ gas• Mechanical power generation
Introduction
Introduction
Examples of ApplicationImpeller of a compressor
Examples of Application• Vaned diffuser for centrifugal compressor
Examples of Application• Turbo charger
Examples of Application
• Schematic of flow in an axial turbine. Contours of pressure are from a CFD calculation
Examples of ApplicationReaction turbine (Francis type):
Examples of ApplicationImpulse turbine (Pelton type):
Examples of ApplicationCutaway view of the GE90 turbofan engine designed for long-range commercial aircraft
Introduction
Description of simple cycle• Specific work, w; thermal efficiency,
η= w/q
Assumptions:• Both compressor and turbine are
isentropic (reversible adiabatic, η= 100 %)
• Pressure losses in both of combustion chamber and heat exchanger are negligible.
• Working fluid is air. It behaves as an ideal gas
• Mass flow rate is constant and combustion process is replaced by heat addition process.
Introduction
• First law of thermodynamics (conservation of energy)
• q – w = Δh• Compressor
(adiabatic, q=0.)
• Turbine
)( 2121 TTchhw
hw
pc
c
)( 4334 TTchhw
hw
pt
t
Introduction• Combustion chamber
)(
.0,
2323 TTchhq
whq
ph
h
ct
h
netth q
ww
q
w
/)1(/)1(
1
2
1
2 )()( thus4,-3 and 2-1 processes Isentropic rp
p
T
T
/)1(/)1(
4
3
4
3 )()( Also rp
p
T
T
23
14
23
2143 1)(
)()(
TT
TT
TTc
TTcTTc
p
ppth
Introduction
]1/
1/[11
23
14
2
1
23
14
TT
TT
T
T
TT
TTth
/)1(
43124312
142312
//,//
& ,/
rTTTthusTPPPPr
PPPPPPrLet
)1
(1)1( /)1(
3
4 rT
T
Introduction
• Open cycle single shaft and twin-shaft arrangements
• Complex with inter-cooling, heat exchange and reheat
• Multi-spool arrangements
• Typical gas turbine design procedures
Introduction
Top Related