Aluratek ADMPF310F Screen ReplacementReplacing the screen in your Aluratek digital photo frame.
Written By: Chris Belair
Aluratek ADMPF310F Screen Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 5
INTRODUCTION
This guide will walk you through how to replace the screen to your digital frame. This is one of themost simplest guides and doesn't take a lot of time at all.
TOOLS:iFixit Opening Tools (1)
Spudger (1)
Aluratek ADMPF310F Screen Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 5
Step 1 — Screen
Using the plastic opening tool, pry off the clips all around the frame. You will hear a popping soundfor every clip
Be sure not to pry to hard because you could crack or break the plastic facing of the device.
Step 2
Lift screen out of place so you canaccess the plugs that connect it.
Be careful not to pull the screen tofar away when placing to the side,many fragile wires are connected.
Aluratek ADMPF310F Screen Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 5
Step 3
Using the plastic spudger tool lift the plastic zif(zero instertion force) connector clip up.
Pull the ribbon cable away from the motherboard.
Be careful as this clip is very frail.
Step 4
Disconnect the red and black cableconnecting the screen to themotherboard by just pulling it out.
Aluratek ADMPF310F Screen Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 5
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2017-06-20 11:44:12 PM.
Aluratek ADMPF310F Screen Replacement
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 5
Top Related