NUS.SOC.CS5248

A Time Series-based Approach for Power

Management in Mobile Processors and Disks

X. Liu, P. Shenoy and W. Gong

Presented by Dai Lu

NUS.SOC.CS5248

Contents IntroductionTime Series based Power

Management Utilization Measurement Prediction Model Speed Setting Strategy

ImplementationEvaluationSummary

NUS.SOC.CS5248

IntroductionMultimedia applications prevalent

on mobile devices 3G/4G wireless network

Devices more and more powerful Samsung SPH-V5400 hand phone is equipped

with a 1.5 GB micro driveEnergy is a scarce resource

NUS.SOC.CS5248

Previous Work CPU

DVFS: Dynamic Voltage and Frequency Scaling Infer task periodicity by work-tracking

heuristic Assume implicit deadlines for interactive

applications Only periodic applications; assumes

applications tell OS their periods and work amount

DiskDRPM: Dynamic Rotations Per Minute Monitor disk request queue length On-disk cache impact not considered

NUS.SOC.CS5248

Why DRPM? Power- RPM relation

Ke: spindle motor voltage R: motor resistance ω: angular velocity

Similar to DVS for processors (P~fV2)

NUS.SOC.CS5248

Contents Introduction Time Series based Power

Management Utilization Measurement Prediction Model Speed Setting Strategy

Implementation Evaluation Summary

NUS.SOC.CS5248

New WorkLow overhead

Prediction with simple statistical model in time series analysis

Processor + disk TS-DVFS + TS-DRPM

Different CPU scaling factor for different tasks Enable coexistence of MM and non-

MM applications

NUS.SOC.CS5248

TS-PM enabled OS kernel

NUS.SOC.CS5248

Prediction Model Box-Jenkins model in time series analysis

Assume a stationary process Statistical properties (mean, variance)

are essentially constant through time. Firs-order autoregressive process (AR(1))

predictor ũt = Φ1 ũt-1+at

Φ1: Correlation coefficient at: Error/ random shock

Sample Autocorrelation Function (SAC)

NUS.SOC.CS5248

Prediction Model Cont.

Estimated demand:

Estimated mean:

Estimated constant( SAC):

TS-DVFS: one AR(1) for every task

TS-DRPM: a single AR(1)

NUS.SOC.CS5248

Measuring utilization CPU

e: full-speed execution time

q: time quantum allocated to the task

Disk r: response time s: scaling factor

NUS.SOC.CS5248

Speed Setting Strategy TS-DVFS

Two level CPU setting Interval T

Subinterval within T

NUS.SOC.CS5248

Speed Setting Strategy TS-DRPM

Performance slow-down Pdiff[i] = a(1-h) × T × Rdiff[i]

Estimated utilization ûi = û + Pdiff[i]/ Th: hit ratea: arrival rateRdiff: rotational latency difference

Choose the lowest RPM level satisfying (ûi- ûmax) / ûmax ≤ threshold

NUS.SOC.CS5248

Contents Introduction Time Series based Power Management

Utilization Measurement Prediction Model Speed Setting Strategy

Implementation Evaluation Summary

NUS.SOC.CS5248

Implementation CPU

300-677 MHz, Transmeta Divide into 5 steps Mapping scaling factor to frequency level

Disk 3000-5400 RPM Divide into 5 steps Assumed power consumption level Trace driven simulation with DiskSim

NUS.SOC.CS5248

Frequency and RPM Mapping

NUS.SOC.CS5248

Contents Introduction Time Series based Power Management

Utilization Measurement Prediction Model Speed Setting Strategy

Implementation Evaluation Summary

NUS.SOC.CS5248

TS-DVFSUp to 38.6% energy saving against LongRun

NUS.SOC.CS5248

TS-DRPMUp to 20.3% saving against TPMperf (oracle)

NUS.SOC.CS5248

Summary Time series statistical model TS-DVFS TS-DRPM

Comments General PM, no QoS measurement like deadline

miss rate Multiple rotational speed disk not commercially

available Increase the accuracy of profiling disk access

patterns. “Hit if response time < τ, otherwise miss.”

NUS.SOC.CS5248

References Chameleon: Application Controlled Power

Management with Performance Isolation, X. Liu and P. Shenoy, Technical report 04-26, Department of Computer Science, University of Massachusetts

Forecasting and time series: an applied approach 3rd ed, Bowerman and O’Connell, Duxbury, 1993

Reducing disk power consumption in servers with DRPM, S. Gurumurthi, A. Sivasubramaniam and H. Franke, IEEE Computer, Dec 2003