R 1240
R620
R 926,5
R 1541
AB10504
2374
01.07.2006
3386
2668
2458
ECO LIFT 2.35
100
32
4042
3040
2997
2593
95-
150
1850
1945
- 20
00
130O
2365
250
Stand
Zeichnungsnummer
2595
AP10501
3060
3600
- 40
40
ECO LIFT 2.35
ECO LIFT 2.30 SPORT
INTER LIFT 2.30
all dimensions in mm
3600workspace width
Installationplan
control column second column
Implementation and minimum requirements to the foundation and installation place
• Foundation measurement to lift in the open air: length in drive-on direction: 1500 mm breadth crosswise to drive-on direction: 3750 mm Attention : For lifts that will be set-up in the open air the foundation has to be executed frost-resistant (appr. 1,1 m deep) and a roof over has to be foreseen.
• Foundation measurement to lift in a hall:
minimum thickness without stone floor and tile layer: 250 mm Concrete grade: B25 minimum pressure resistance of installation place: 100 N/cm² Should there be an isolation between stone floor and floor plate we recommend to remove this. The surface of the foundation has to be even and level for all lifting platform types. The lower soil has to meet the general guidelines for development sites (DIN 1054).
• Power supply:
5 x 1,5 mm² Ölflex / 400 V /50 Hz, protected with 16A inert The power supply to the lift has to be done ex works.
• Doweling:
necessary amount:10 pieces uncracked concrete: Glue cartridge HVU M16x125 Order number 256694 Anchor pole HAS M16x125/38 Order number 66004 (up to 2 cm floor covering) Anchor pole HAS M16x125/108 Order number 259941 (up to 10 cm floor covering) cracked concrete: Glue cartridge HVU-TZ M16x125 Order number 311370 Anchor pole HAS-TZ M16x125/30 Order number 332519 (up to 2 cm floor covering) Anchor pole HAS-TZ M16x125/100 Order number 332521 (up to 10 cm floor covering) If unknown concrete situation, we recommend to suppose cracked concrete!
We recommend to put up each column bended outside with 0,4° ( = 1cm / meter ) in order to compensate the load with a lifted car.
If the installation will be made by a third person an examination of a well informed expert is generally necessary for all lifts before putting in operation.
Pay attention to technical fitting instructions!
01.02.2006
Stand
Zeichnungsnummer
2459
2650
2350
5000
1000
- 200
0
3600workplace width
6000
wor
kpla
ce le
ngth
- 700
0
2575distance steelplates
2364
control-column
control-unit
second column
Stand
AP10501ECO LIFT 2.35
ECO LIFT 2.30 SPORT
INTER LIFT 2.30 Installationplan 01.02.2006
all dimensions in mm
Top Related