X-Wingjemmagazin.hu/Promo/JEMSWOrigami.pdf · prefer pure origami, skip to #15 to form the wing-tip...
13
© 2005 by Ching-Yu Hung X-Wing Developed in Feb ’05, diagrammed Nov ’05, by Ching-Yu Hung Start with a square piece of paper. Fold into water bomb base with the desired color side out. 1. Make a waterbomb base. Mountain fold on diagonals and valley fold on horizontal and vertical halves. Push the paper so that the center rises up like a pyramid, then lay it down and flatten it. 2. Take one flap and inner-reverse fold. 3. Outer-reverse fold that flap so that the obtuse angle is slightly over the center line, and the bi-sect angule line of the flap is parallel to the base. 4. Repeat 2 and 3 on all three other flaps. Then, fold in the bottom part to sharpen the wings. 5. Fold in one of the flaps then out, as shown.
Transcript of X-Wingjemmagazin.hu/Promo/JEMSWOrigami.pdf · prefer pure origami, skip to #15 to form the wing-tip...
© 2005 by Ching-Yu Hung
X-Wing
Developed in Feb ’05, diagrammed Nov ’05, by Ching-Yu Hung Start with a square piece of paper. Fold into water bomb base with the desired color side out. 1. Make a waterbomb base. Mountain fold on diagonals and valley fold on horizontal and vertical halves. Push the paper so that the center rises up like a pyramid, then lay it down and flatten it.
2. Take one flap and inner-reverse fold.
3. Outer-reverse fold that flap so that the obtuse angle is slightly over the center line, and the bi-sect angule line of the flap is parallel to the base.
4. Repeat 2 and 3 on all three other flaps. Then, fold in the bottom part to sharpen the wings.
5. Fold in one of the flaps then out, as shown.
© 2005 by Ching-Yu Hung
6. Repeat 5 on all three other flaps.
7. Arrange the design 3-dimensional, and prop up the cockpit, and we have the basic body design.
8. Making the engines involves scissor cuts. If you prefer pure origami, skip to #15 to form the wing-tip laser cannons. Cut each wing along the front edge, about 5/6 of the length from the tip.
9. Fold the upper flaps up, and lower flaps down, on the outer flap of each wing, parallel to the body of the fighter. The 4 folded up flaps shall become the engines.
10. Outer reverse fold an engine flap as shown.
11. Fold the tip of the engine flap in and out.
© 2005 by Ching-Yu Hung
12. Sink the top portion of engine as shown.
13. Use a chopstick to shape the engine round. 14 Repeat #10 to #13 on all three other engines.
15. Inner-reverse fold the wing tips forward and sharpen to form laser cannons, and we’re done.
Jedi Master Yoda
Fumiaki Kawahata
ASOCIACIÓN ESPAÑOLA DE PAPIROFLEXIAAPTDO. DE CORREOS 13.156 - 28080 MADRID
CORREO ELECTRÓNICO: [email protected]
www.publynet.com/aep
1
8
==
10
11
6
54
3
7
9
2
Ron
Typewritten Text
Visit Www.PedagoNet.Com
ASOCIACIÓN ESPAÑOLA DE PAPIROFLEXIAAPTDO. DE CORREOS 13.156 - 28080 MADRID
CORREO ELECTRÓNICO: [email protected]
www.publynet.com/aep
12 14
16
17 18
20 21
23
25 27
Plegado de la capucha, figuras 19 a 22.
19 22
26
15
24
13
Repetir 12 y 13 enel otro lado.
ASOCIACIÓN ESPAÑOLA DE PAPIROFLEXIAAPTDO. DE CORREOS 13.156 - 28080 MADRID
CORREO ELECTRÓNICO: [email protected]
www.publynet.com/aep
28 29 30
32 33
3435 36
37
Segundo plegadode la mano.
39
A
B
Primer plegadode la mano.
38A
B
31
Repetir 28 a 31 en elotro lado.
ASOCIACIÓN ESPAÑOLA DE PAPIROFLEXIAAPTDO. DE CORREOS 13.156 - 28080 MADRID
CORREO ELECTRÓNICO: [email protected]
www.publynet.com/aep
Realizar los restantes plegados de lamano indicados en la figura siguiente.
1
1
1
2
23
4
4
4
5
6
7
8
9
10
41
42 43
4546
47
44
Etapa intermedia del plegadode la figura 42.
42'
4948
50 51
40
ASOCIACIÓN ESPAÑOLA DE PAPIROFLEXIAAPTDO. DE CORREOS 13.156 - 28080 MADRID
CORREO ELECTRÓNICO: [email protected]
www.publynet.com/aep
5857
56
59
Dar volumen a lacabeza y cuerpo
53 5452
Utilizando papel de 25 x 25cm. la figura quedará de 9 cm.de altura.
55
