A Low Cost ATmega8A Based RA Stepper Motor Controller and ...
Wireless Stepper Motor Controller Board - Robomart.com
8
Stepper Motor Controller Board
description
Robomart have huge inventory of stepper motor controller board. You can buy stepper motor driver and other dc motor driver from Robomart.com
Transcript of Wireless Stepper Motor Controller Board - Robomart.com
Stepper Motor Controller Board
Our Stepper Motor Controller Board
L298NStepper Motor Driver Board
BTS7960 43A H-BridgeStepper Motor Driver Board
ULN2803Stepper Motor Driver Board
4 AMPStepper Motor Driver Board
L298N Stepper Motor Controller Board
This stepper motor driver module for arduino smart car robot. In this module have L298N chip. L298N chip can directly drive two 3-30 volt stepper dc motor and provide 5 volt interface.
Product Parameters
Dual H-Bridge L298N Drive Chip Terminal driver part of the supply area VMS: +5 V ~ +35 V Drive part of the peak current Io: 2A / Bridge The control signal input voltage range: 4.5-5.5V low 0V
high Maximum power consumption: 20W Storage temperature: -25 ~ +130 Driver board Weight: 33g
Product Code: RM0162
BTS7960 Stepper Motor Controller Board
Double BTS7960 43A H-Bridge is high power stepper motor driver board arduino. This BTS 7960 is a fully integrated high current half bridge for stepper motor drive application.
Product Parameters
Double BTS7960 Half Bridge Board Operating voltage 24 V Continuous current 43A Max
Product Code: RM0445
ULN2803 Stepper Motor Controller Board
ULN2803 is a stepper motor driver for arduino. It can control 2 4-phase stepper motor at same time. There are ten pins, 8 pins supply , 5 volt power input and leads to an external power supply.
Product Parameters
Working voltage DC +5V Drive capability 500 MA \ 50V Can drive four-phase wireless stepper motor
Product Code: RM1138
4 AMP Stepper Motor Controller Board
This driver board support motor upto 4 amps/phase at 50 volts. This is a Single-chip bipolar sinusoidal micro-step stepping motor driver board.
Product Parameters
Drive 4.5 and 4 AMP sustained at 50 volts 4 decay modes from 20 to 80% Automatic idle drive power reduction Output monitor pins (Down / Alert)
Product Code: RM1140
Contact Us
B5 C Block Sector 31, Above Indian Overseas BankNoida Uttar Pradesh 201301
India
Mob. +91-8744000555Tel. +91-120- 4317229
Email ID [email protected]. https://robomart.com
Thank You
