Wireless Liquid Level Acquistion
-
Upload
jamesstenhouse -
Category
Documents
-
view
213 -
download
0
Transcript of Wireless Liquid Level Acquistion
-
8/20/2019 Wireless Liquid Level Acquistion
1/1
Click on “Pick a Sensor” buon
Sensors are automacally select-
ed based on prior setup. Click
“pick a sensor” if you want to
change sensors.
1
Click on “Pick Well” buon
Connect Well Analyzer 2 Select Liquid Level
Click on “Liquid Level”
buon
3 Pick Sensors 4 Zero the Pressure Sensor
6a Start Acquisition from Sensor
Click the “Zero Off set” tab,
then click “Get New Off set”
When finished, close popup window to proceed with
tesng. Changes save automacally.
Click the “Use Shown Value
to accept new off set
Wireless Liquid Level AcquisitionWireless Liquid Level AcquisitionWireless Liquid Level Acquisition
Press “Acquire” switch on gu
and wait for the “Fire” light tstop blinking, then press “Fire
buon when ready to shoot
Make sure the chamber pres
sure is greater than the well
pressure.
6b Start Acquisition from Laptop
The background no
screen will show. C
“Take Shot”.
Click on
“Start Ne
Test” bu
Use methods and tools
to refine results
View Pressure
Buildup
5 Install Sensors on Well
7 Results, Finish Pressure BuildupIf using a PT, observe casing pres-
sure buildup for one to two mins,
then click “End Pressure Buildup”
to stop test.
Charge the gas gun 150-300 psi
above surface pressure on the well.
Close the gun bleed valve.
Open casing valve between gun
and wellhead.
Close casing valve to the flowline.
QAD 5000-7