WigJig Pattern 6
description
Transcript of WigJig Pattern 6
Wig Jig Pattern 6
Step 1
Place the pegs in the
wig jig as shown. This
will make a cross
pattern with an extra
peg at the top.
Step 2
Cut a piece of wire 12
inches long. Place one
end of the wire
between the top peg
and the peg directly
below it.
Step 3
Begin wrapping the
wire around the top
peg.
Step 4
After wrapping the
wire completely
around the top peg,
bring the wire down on
the right side of the
two pegs below it.
Then pull the wire
along the bottom edge
of the two left pegs.
Step 5
After wrapping the
wire completely
around the left peg,
bring the wire up on
the right side of the
peg to the right and
bottom. Then pull the
wire along the right
side of the two bottom
pegs.
Step 6
After wrapping the
wire completely
around the bottom
peg, bring the wire up
on the left side of the
two pegs above it.
Then pull the wire
along the top edge of
the two left pegs.
Step 7 Step 8 Step 9 Step 10 Step 11 Step 12
After wrapping the
wire completely
around the right peg,
bring the wire up on
the left side of the peg
to the left and top.
Then pull the wire
along the right side of
the two top pegs.
Wrap the wire around
the top peg. This will
create a second loop
around the top peg.
Take the wire form off
of the wig jig. Use your
wire cutters to cut off
the end of the wire.
This will leave a
simple loop on one
side of the form.
Repeat step 9 on the
other side of the wire
form.
Using your chain nose
pliers, grasp the side
of the loop.
Close the loop by
moving the open side
of the loop back until
the loop is closed.
Step 13
Repeat steps 11 and
12 for the other side of
the wire form.
Step 14
Line up the top two
loops so they overlap.
Make several forms
and link them together
for a necklace,
bracelet or earrings.
Also, try hanging
beads off of loops.