Note: as the assembly process involves voltage exceeding human safety, non professionals should not operate. During the assembly process, insulation and protection measures should be taken, wiring should be checked repeatedly, and the product should be placed in a place hard to touch by children and the elderly.

5. Assembly procedure5.1 Assembly preparation* power supply WZ-6008 ,H08 set of shells,switching power supply* Tools, accessories (DC power supply, product power cord,multimeter, screwdriver,Stylus, etc.).5.2 Assembly steps:

Note: The texture of the shell is soft, and it may be slightly deformedduring transportation.If there is a gap during assembly, please straightenit gently before assembling.1. Accessories check: Check whether the accessories of H08 are completeaccording to the accessories list or the accessory drawing.2. WZ-6008 power-on check: connect the longest power cord to theWZ-6008 socket, DC Regulated power supply energizes WZ-6008,whether the WZ-6008 switch is normal.3. Disassemble the shell and install on the rear panel: assemble the switch,pin socket and fan to the lower cover.

4. Switching power supply assembly: Assemble the power supplyto the lower cover.5. The connection of the power cord: connect the power cord (dangerousactions, non-professionals are not allowed to operate)Use the brown wireto connect the switch and the live wire (L) of the switching power supply;then use the brown wire to connect the switch and the pin FireWire (L) ofthe seat; connect the zero wire (N) of the product socket with the blue wireand the zero wire (N) of the switching power supply;Connect the groundwire of the product socket (E) and the ground wire of the switching powersupply (〨) with a yellow and green color wire.6. Switching power supply test: After checking the wiring again, use thepower cord to supply power, and use a test pen to check the powerAnd insulation status. Power-on test.7. Adjust the output voltage: use a multimeter to measure whether the 60Vpower output is normal, and then use small screws The knife fine-tunesthe output value of the power supply to about 66V

8. Fan power supply board assembly: Assemble the fan powersupply board to the corresponding position.

9. Front panel WZ-6008 assembly: remove the front panel frame, and WZ- 6008snaps onto the shell.10. Power cable and fan cable: connect the WZ-6008 cable to the output of theswitching power supply The power supply terminal of the fan power supply board isconnected to the output end of the switching power supply, and the seat of

the fan isinserted into the fan power supply board on.

11. Power-on test: plug in the power cord, turn on the switch, and the casingfan will run (Note: temperature-controlled fan, below 40 ℃, stop after 3S afterpower on, run at 40 ℃ -45 ℃ at low speed, 45 ℃ -50 ℃ High-speed operationabove 50 ℃ high-speed operation).12. Install the housing screws.

13. Final power-on test.