ROCKQUESTConveyor Belting one & two Ply I-warp

VIKING ROCKQUEST Conveyor Belting with an I-Warp construction has been designed for the toughest belting applications where low-stretch, impact-resistant, high strength belts are needed.

Benefits industries applications

• Impact Resistant• Rip Resistant• Low-Stretch• Superior Lace Retention• High Cover Adhesion• Cut, Gouge, and Tear Resistant• Load Support• Outstanding Troughability

• Quarries• Log Handling• Cement Industry• Recycling• Automobile Shredding• Heavy Metal Scrap• Mining• Construction

• Large Stone• Heavy Ore• Bucket Elevators• Copper Ore• Feeders Under Rock-Crushers• Primary Crushers• Magnetic Separators

VIKING™ ROCKQUEST One and Two Ply I-Warp belt’s reinforced carcass construction resists rips, tears and gouging caused by heavy impacts. The belt provides exceptional durability because of it’s tough synthetic carcass and heavy duty RMA Grade I covers. It also has excellent bolt-holding capabilities for buckets and mechanical fasteners, a significant improvement over standard straight warp belts.

the i-warp design

VIKING ROCKQUEST S P E C I F I C A T I O N S

Cover Gauge................................. 1/4” x 1/8”Belt Carcass Gauge ..................... 0.1295Working Tension Rating ............ 440 PIWCover Grade ................................ RMA IConstruction Warp .................... PolyesterConstruction Fill Weft ............... NylonCover Tensile Strength ............... Min. 2600 PSICover Elongation ........................ Min. 500% Cover Hardness ........................... 63+3 (SHORE-A)Minimum Pulley Diameter ........ 12” Temperature Range ..................... -40C to +60C

3/8”x1/8”0.1295800 PIWRMA IPolyesterNylonMin. 2600 PSIMin. 500%63+/-3 (SHORE-A)16”-40C to +60C

1-Ply 2-Ply