Vent window installed

Install door frame side latch

The other door

Windshield

Finish windshield installation

Radio antenna installed

Door strap

Cooling shrouds to be cleaned/repaired

Painted the frame black

Other side of the frame

From the rear

Top, sides, bottom – some tiny spaces to paint

New brakes and cylinders

Brake hub turned – painted Aluminum

13mm wrench to adjust brakes

New wide tires for the rear - radials

brake adjusters

Brake cleaner used prior to finish painting and mounting brakes and cylinders

Tremclad gloss black paint

Original brake cylinders - seized

Rear brakes finished

Engine cover (bottom) repainted

Engine cover repainted - top

Engine mounting holes - front

Arrow shows the speedo drive

Speedo cable – engine mounted

Square drive inside

Speedo cable – side view – mounts on the motor

Use the small brake fluid container for filling the reservoir

Bleeder kit mounted to the front brake nipple – 8mm wrench required

Pumped out brake fluid from the brake lines

Dirty – should be clear

Fill the reservoir

Left rear brakes being bled – you can do this by yourself, just look under the cabin

Keep refilling the reservoir as you bleed the brakes

Right rear ready

Watch through the door gap when you do the front brake

Brake bleeder kit – you can make your own

How to make a brake bleeder – start in the kitchen

Get yourself a plastic container with a lid, clear tubing to fit tightly over the bleeder nipple and a vent hole in the lid