Vaccumm Leakage Sensor
Transcript of Vaccumm Leakage Sensor
-
8/12/2019 Vaccumm Leakage Sensor
1/1
WarningThe VLS-07 is designed to be a warning device for vacuum leakagedetection. When properly installed on an ANVER vacuum lifter, theoperator will be warned of a slow vacuum leakage and should haveadequate time to safely lower the attached load. If the alarm signal isignored and the lifting operation is continued, the vacuum loss mayadversely affect the vacuum "hold", possibly resulting in serious injury
to the operator. The VLS-07 is not designed for nor effective indetecting fast leaks or sudden failures of the vacuum system.
Vacuum Leakage Sensing Systems
VLS-07 Vacuum Leakage Sensor
Principle Of OperationThe VLS-07 Vacuum Leakage Sensor is a vacuum level differential detectorwhich is pre-programmed to activate the alarm at a 10% reduction invacuum with a leakage rate of less than 1.5 inches Hg per second.The alarm will continue until a sufficient increase in vacuum is achieved,indicating no additional leakage is present, or the indicated vacuum leveldrops below 5 inches Hg. The horn, LED (red light) and LCD (digital
display) can be tested by pressing and holding the "Test Button" forapproximately 3 seconds. The unit is also equipped with a low batteryindicator which will cause the horn to "chirp" and the LED to flash whenbattery power is low. The battery should be replaced immediately with astandard 9V lithium battery. The auxiliary output jack on the VLS-07 is anopen collector output which can be connected directly to the VLS-07-AUX-S(auxiliary siren/strobe), or to another 1/0 device, such as an emergencystop function on a CNC control, through a solid state relay. The unit isprovided with Mounting Holes for 4 #10 Self-Tapping Screws.
The Latest in SolidState VacuumLeakage Detection
The VLS-07 monitors the vacuum levelautomatically. If vacuum is lost during alift a loud horn sounds, and a red lightflashes to warn the operator.The VLS-07 monitors vacuum level evenif the operator is not looking at thelifter,a useful and popular option.
The VLS-07 is a battery powered unit
consisting of a pressure sensor, an audible
warning horn, red warning light, and test
switch, all controlled by a solid state
microchip. All ANVER Vacuum Lifters,
Vacuum Tilters and Specialty VacuumLifting Machinery can be equipped with a
VLS-07 Solid State Vacuum Leakage
Sensor and Warning System. The system
is packaged in a rugged polycarbonite
enclosure with a 1/4" push-to-connect fitting
for tubing connections.
During each lifting cycle the programmed
'intelligent' processor senses the peak
vacuum level. From this point, a 10% loss
VACUU
MLEVE
L(IN.H
g)
TESTB
UTTON
VACUUMINPUT
AUX.OUTPUT
WAR
BATT
ERY
MOUNTINGHOLES
1.97[50]
MOUNTINGHOLES
1/4" OD PUSH-TO-CONNECTFOR TUBE CONNECTION TOVACUUM MANIFOLD
3.15[80]
5.83
[148]
1.75[44]
0.94[24]
6.30[160]
2.24[57]
2.50[64]
VACUU
MLEAK
AGES
ENSOR
ANDW
ARNIN
GSYST
EMBAT
TERY
VLS-07
THIS VACUUM LEAKAGE WARNING DEVICE WILL NOTPROVIDE TIMELY WARNING TO THE OPERATOR THAT AREDUCTION IN VACUUM HAS OCCURRED DUE TOINCORRECT USE OF A VACUUM LIFTER, SUCH ASOVERLOADING, LIFTING OVERSIZED LOADS, UNBALANCEDLIFTING OR IMPROPER OPERATION OF ANY KIND.
Bulletin No. 13200205Revision: E Control No. 908130
of vacuum with a leakage rate of less than
1 in. Hg per second from that peak level
will trigger the horn and light, informing the
operator of a leak. The alarm will not sound
on the detach cycle as with other primitive
systems using preset switches. Even the
smallest leak anywhere in the system will
be detected. The VLS-07 system
automatically monitors the vacuum level fo
the operator.
Features
Advanced Solid State Circuitry with Micro-Controller
Precise, Reliable, Board Mounted Vacuum Transducer LCD Digital Display of Vacuum Level in Inches of Hg
Audible Warning Horn
Bright Flashing Red LED Warning Light
Push-to-Connect Vacuum Source Portto Connect to Vacuum Manifold
Auxiliary Output Jack to Connect to OptionalVLS-07- AUX-S Auxiliary Siren/Alarm
Easy Access to Battery Compartment
Low Battery "Chirp" Indicator
Light / Horn / LCD Test Button
Powered by One Standard 9V Lithium Battery (included)
Weight: 8 oz
Ordering Information: Order by the Part No
For more information on the VLS-07-AUX-S reference Bulletin No. 132 00 343
36 Parmenter Road Hudson MA 01749 USA 978-568-0221 800-654-3500 FAX 978-568-1570 www.anver.com E-Mail: [email protected]
010230 This spec sheet was adapted for print from our website. Additional information and photos are available at www.anver.com.