User s Guide - hizbiz.comhizbiz.com/Downloads/user_guide_web_hook_sheaves_101813.pdf · User’s...
Transcript of User s Guide - hizbiz.comhizbiz.com/Downloads/user_guide_web_hook_sheaves_101813.pdf · User’s...
Manufacturers of Equipment for the Electrical and
Telecommunications Industries
Hook Sheave User’s Guide
Hook Sheave
HIS Business Manufacturing Company
Tel (619) 447-0009 (800) 292-9831 Fax (619) 447-4695
Hook Sheave
Safety and Procedure Recommendations
INSPECTION / SET-UP / OPERATION Always know and follow Cable-Manufacturers cable requirements: Bend-radius, sidewall
pressure, line tension. Select correct products to meet those requirements.
Always understand pulling forces: Line-tension in relationship to load-on-sheave.
Always be certain that tie-off (tie-down) point and equipment is in excellent working
condition, secure and capable of load.
Always inspect equipment and safety apparatus and pulling-line before use.
Always use safety latch and clips.
Always follow industry standards when using this equipment.
Always know and follow company work methods.
Never allow untrained or unauthorized personnel to set up puling equipment and / or
operate pulling equipment.
Never allow anyone to operate equipment or stand in line of cable-pulling.
Never exceed rated capacity of equipment / apparatus: Hook Sheave, Duct Rollers, Rim
Rollers, Pullers, Pulling-Line, etc. (Manufacturer’s ratings, use of Dynamometers or
Tensiometers)
Never shortcut a pull using an unsafe pulling angle.
Proper pulling
angle, the hook
and the cable
are at the same
angle. This is a
proper pull.
Not a proper pulling
angle, the hook and
the cable are at
different angles. This
alignment can cause
damage to the hook
and sheave.
HIS Business Manufacturing Company
Tel (619) 447-0009 (800) 292-9831 Fax (619) 447-4695
Hook Sheave
Components and Specifications
HIS Business Manufacturing Company
Tel (619) 447-0009 (800) 292-9831 Fax (619) 447-4695
Congratulations on your selection of the HIS Hook Sheave.
HIS Business Mfg. Co., warrants to purchaser of HIS Hook Sheave that if any assembly part
thereof in the judgment of manufacturer is proven to be defective in material or workmanship within
(1) year on original purchase date, such defects will be repaired or replaced (at manufacturer’s op-
tion) free of charge for parts and labor.
Warranty
NOTES:
Date Purchased:
Serial Number: