User Manual - WebstaurantStore.comPosition hot dogs on the smaller, left compartment and buns on the...

9
User Manual www.AvantcoEquipment.com 1 Hot Dog Steamers Models: HDS100, HDS175, HDS200 Please read and keep these instructions. Indoor use only. 06/2018 User Manual Intertek

Transcript of User Manual - WebstaurantStore.comPosition hot dogs on the smaller, left compartment and buns on the...

Page 1: User Manual - WebstaurantStore.comPosition hot dogs on the smaller, left compartment and buns on the wire rack in the right compartment. For HDS175, place buns on the upper rack and

User Manual

www.AvantcoEquipment.com 1

Hot Dog SteamersModels: HDS100, HDS175, HDS200

Please read and keep these instructions. Indoor use only.

06/2018

User Manual

Intertek

Page 2: User Manual - WebstaurantStore.comPosition hot dogs on the smaller, left compartment and buns on the wire rack in the right compartment. For HDS175, place buns on the upper rack and

User Manual

2 www.AvantcoEquipment.com

BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS.

SpecificationsItem Capacity Wattage Plug Weight Dimensions

HDS100 100 hot dogs, 48 buns 120V, 1300W NEMA 5-15P 27 lbs. 18.5”W x 14”D x 16”H

HDS175 175 hot dogs, 40 buns 120V, 1200W NEMA 5-15P 28 lbs. 15.5"W x 17"D x 19.5"H

HDS200 200 hot dogs, 48 buns 120V, 1300W NEMA 5-15P 35 lbs. 18.5”W x 14”D x 20”H

Explanation of Graphical Symbols

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user. It provides a warning for the presence of uninsulated “dangerous voltage” within the product’s enclosure. This voltage may be of sufficient magnitude to constitute a risk of fire or electric shock to persons.

The exclamation point, within an equilateral triangle, is intended to alert the user of important operating and maintenance instructions accompanying the appliance.

Important SafeguardsWhen using electrical appliances, the following safety precautions should be followed:

1. Read all instructions.

2. Do not touch hot surfaces. The surfaces are liable to become hot during use.

3. To protect against electrical shock, do not immerse cord, plugs, or the base in water or other liquid.

WARNING, TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK)

NO USER-SERVICEABLE PARTS INSIDE

REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE

PERSONNEL ONLY.

WARNINGRISK OF FIRE OR ELECTRIC SHOCK

DO NOT OPEN

Page 3: User Manual - WebstaurantStore.comPosition hot dogs on the smaller, left compartment and buns on the wire rack in the right compartment. For HDS175, place buns on the upper rack and

User Manual

www.AvantcoEquipment.com 3

4. Close supervision is necessary when any appliance is used by or near children.

5. Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts.

6. Do not operate any appliance with a damaged cord or plug; after the appliance malfunctions; or after any additional damage. Return appliance to the nearest authorized service facility for examination, repair, or adjustment.

7. The use of accessories, not recommended by the appliance manufacturer, might cause injuries.

8. Do not use outdoors. This appliance is for commercial use.

9. Do not let cord hang over edge of table or counter, or touch hot surfaces.

10. Do not place on or near a hot gas or electric burner, or in a heated oven.

11. Extreme caution must be used when moving an appliance containing hot oil or other hot liquids.

12. Only use this appliance for its intended use.

13. Avoid scratching the glass door or nicking edges. Upon delivery, if your door has a scratch or nick, contact customer service before using the streamer. The tempered, safety glass door is more resistant to breakage than traditional glass.

14. The appliance is off when power switch control is in the “off” position.

Before Using Your Hot Dog SteamerPrior to your first use, follow these instructions:

1. Remove the steamer and all parts from the box.

2. Place the unit on a flat sturdy surface, facing forward with the dial on the left hand side.

3. Open the two top flaps and remove all parts and packing foam. Set the parts aside. Before the first time use, all parts should be properly washed and sanitized.

4. Slide in the back and front panel of window glass.

5. Ensure the valve drain cap is tightly screwed close.

6. For HDS100 and HDS200, pour 6 qt. of hot water into the unit's base. For HDS175, capacity is 8 qt. of water. This should cover the heating elements. DO NOT OVERFILL.

7. After inserting the water, place the perforated rectangular base on the left side of the unit.

8. On the right side of the unit, place the square base plate with the control lever.

9. Separate the two sections by sliding the partition piece into the left slots.

10. Place the hot dog rack in the left compartment. Ensure the rack is elevated by its feet for proper circulation of steam.

11. Place the bun rack in the right compartment.

12. Place the lid beam in the middle of the unit's open top.

For HDS100 and HDS200, follow steps 7-13.

Page 4: User Manual - WebstaurantStore.comPosition hot dogs on the smaller, left compartment and buns on the wire rack in the right compartment. For HDS175, place buns on the upper rack and

User Manual

4 www.AvantcoEquipment.com

13. Place the two lids on the unit's edges and beam. Adjust the beam as needed.

14. Plug the unit into a grounded and properly-sized electrical outlet to minimize shock and fire hazards. For further specifications, refer to the electrical requirements outlined on the serial tag on the operator's side of the unit.

15. Turn on the streamer and set the thermostat control to the highest setting, until steam is generated.

16. After stream is produced, turn back the thermostat control to 130°F .

17. Position hot dogs on the smaller, left compartment and buns on the wire rack in the right compartment. For HDS175, place buns on the upper rack and place hot dogs on the lower rack. Allow adequate room around the hot dogs and buns to enable stream circulation.

18. Control the bun compartment's steam by adjusting the humidity control lever, located in the bun compartment under the wire rack.

19. Keep the lids closed when not serving.

20. Add hot water as needed to maintain the water level. Do not let the unit burn dry. If burned dry, turn off the unit and allow it to cool completely. Adding water to a dry, hot unit could cause damage to the parts.

Cleaning and MaintenanceTo maintain proper sanitation, this hot dog steamer must be cleaned daily. Stainless steel is corrosion-resistant, but to elongate your product's life and service quality it should be cleaned after each use.

1. Unplug the power cord from the electrical outlet.

2. Allow the unit to cool completely.

3. Remove remaining hot dogs and buns.

4. Drain water via the drain pipe, accessible on the operator's side.

5. Detach all removable parts: bun rack, perforated trays, steam control lever, partition, and glass panels. Thoroughly clean the unit and parts. Do not immerse the unit in water or other liquids. Liquids could enter the electrical compartment and cause a short circuit or electrical shock.

6. Do not store unit with water in the reservoir.

Attack tough grease, oil, and carbon with this ready to use decarbonizer and degreaser. Its unique formula is designed to clean ovens, grills, hoods and a wide variety of other surfaces.

Page 5: User Manual - WebstaurantStore.comPosition hot dogs on the smaller, left compartment and buns on the wire rack in the right compartment. For HDS175, place buns on the upper rack and

User Manual

www.AvantcoEquipment.com 5

Using Your SteamerTo start your streamer, push the power switch. Allow 15 – 45 minutes to preheat the streamer, depending on the water volume and temperature. For quick steam, turn the thermostat to max and use hot water. To receive the best results, do not load the maximum capacity of hot dogs and buns at once. Instead, allow steam to circulate the food.

Temperature Control KnobThis thermostatic switch controls the temperature inside the steamer from 95-175°F. Turn the thermostat knob to adjust for your desired temperature.

Troubleshooting GuidePROBLEM POSSIBLE CAUSE SOLUTIONCondensation on glass Cool air coming in contact with the

warm steamerDo not place the unit near cool air vents

Burnt hot dog casing Generating too much steam Turn the thermostat down to a lower setting

Soggy buns Generating too much steam Adjust the steam control level

Dry buns Not generating enough steam Adjust the steam control level and check the water level

Hot Dog Steamer Circuit Diagram(HDS100 & HDS200)

Page 6: User Manual - WebstaurantStore.comPosition hot dogs on the smaller, left compartment and buns on the wire rack in the right compartment. For HDS175, place buns on the upper rack and

User Manual

6 www.AvantcoEquipment.com

Exploded Parts Diagram(HDS100 & HDS200)

Parts Diagram # Part Name Replacement Part #

1 Handle 177HDSP1

2 Top Cover 177HDSP2

3 Cover Holder 177HDSP3

4 Glass Panel 177HDSP4S (HDS-100), 177HDSP4L (HDS-200)

5 Separation Plate 177HDSP5S (HDS-100), 177HDSP5L (HDS-200)

6 Hot Dog Plate 177HDSP6

7 Bun Plate 177HDSP7

8 Front Panel

9 On / Off Rocker Switch 177HDSP9

10 Thermostat Knob 177HDSP10

11 Thermostat 177HDSP11

12 Drain Plug 177HDSP12

13 Drain Plug Support Plate

Parts Diagram # Part Name Replacement Part #

14 High-Limit Thermostat

15 Terminal Block

16 Rear Bar

17 Wire Buckle

18 Power Cord 177HDSP12

19 Foot 177HDSP19

20 Lower Bracket

21 Heating Element 177HDSP21

22 Bun Rack 177HDSP22S (HDS-100), 177HDSP22L (HDS-200)

23 Hot Dog Rack 177HDSP23

24 Rear Board

25 & 26 Steam Plate with Handle 177HDSP25

27 Cabinet

Not Shown Drain Plug Insert 177HDSP13

Page 7: User Manual - WebstaurantStore.comPosition hot dogs on the smaller, left compartment and buns on the wire rack in the right compartment. For HDS175, place buns on the upper rack and

User Manual

www.AvantcoEquipment.com 7

Hot Dog Steamer Circuit Diagram(HDS175)

Page 8: User Manual - WebstaurantStore.comPosition hot dogs on the smaller, left compartment and buns on the wire rack in the right compartment. For HDS175, place buns on the upper rack and

User Manual

8 www.AvantcoEquipment.com

Exploded Parts Diagram(HDS175)

Parts Diagram # Part Name Replacement Part #

1 Top Cover

2 Baffle Plate 1 of Top Cover

3 Baffle Plate 2 of Top Cover

4 Left Board

5 Left Brace

6 Left Hot Dog Rack 177PHDS1

7 Front Baffle 1

8 Front Baffle 2

9 Front Glass Door 177PHDS2

10 Glass Door Handle 177PHDS3

11 Front Baffle 3

12 Cord and Plug 177PHDSCORD

13 Inlet Float

14 Relay

15 Power Cord Fixer

16 Front Panel

17 Indicator 177PLIGHTORG

18 Switch 177PHDS4

19-20 Knob 177PHDSKNOB

Parts Diagram # Part Name Replacement Part #

21 Foot 177PHDSFOOT

22 Foot Base

23 Tank

24 Front Board Fixer

25 Tube on Tank

26 Valve 177OHDS5

27 Heating Element 177PHDSELMNT

28 Right Hot Dog Rack 177PHDS6

29 Back Baffle 1

30 Back Baffle 2

31 Right Board

32 Tong

33 Tong Hanger

34 Right Brace

35 Back Glass 177PHDS7

36 Food Container

37 Bun Rack 177PHDS8

38 Baffle Plate 3 of Top Cover

Not Shown Thermostat 177PHDSTHERM

Page 9: User Manual - WebstaurantStore.comPosition hot dogs on the smaller, left compartment and buns on the wire rack in the right compartment. For HDS175, place buns on the upper rack and

User Manual

www.AvantcoEquipment.com 9

Limited WarrantyAll equipment, which is sold under Avantco trademark and used for commercial purpose is warranted against defects in materials and workmanship. The warranty runs for six months from the time of purchase and is for the benefit of the original purchaser only. All other Warranties, Expressed or Implied, Statutory or Otherwise, including Without Limitation any implied Warranty of Merchantability or Fitness for Purposes are excluded. The Seller shall in no event be liable for direct, indirect or consequential damages in connection with Avantco commercial products.

This warranty is not effective if damage occurs because of accident, carelessness, improper installation, lack of proper set-up, supervision when required or if the equipment is installed or operated in any manner contrary to the installation and operating instructions. Work performed by unauthorized personnel or unauthorized service agencies voids this Warranty. The use of unfiltered water in this unit will void the warranty.

This warranty does not apply to, and Avantco is not responsible for, any warranty claims made on products sold or used outside of the contiguous United States