USER MANUAL - ILUMINAR Lighting · USER MANUAL iLi6 1-877-540-5588 iluminarlighting.com...

6
USER MANUAL iLi6 1-877-540-5588 iluminarlighting.com [email protected] IL-i627FSG-120 IL-i627FSG-480

Transcript of USER MANUAL - ILUMINAR Lighting · USER MANUAL iLi6 1-877-540-5588 iluminarlighting.com...

  • USERMANUALiLi6

    1-877-540-5588 iluminarlighting.com

    [email protected]

    IL-i627FSG-120IL-i627FSG-480

  • 2

    CONTENTS

    • Observe all safety precautions (see page 10), seek the services of a qualified/certified/licensed/insured electrician, or call ILUMINAR Lighting technicians for assistance.

    • DO NOT handle or touch the fixture while in use.

    • DO NOT touch diodes or apply direct force to the diodes as this can/will cause permanent damage.

    • Connect the fixture only to the power sources of the appropriate voltage using the correct AC plug type. Protect power cables from being pinched, walked on, or otherwise damaged. Be especially careful where the power cable enters the power outlet to the unit. Only connect the fixture to an electrical outlet or extension cord of comparable standard and level rating. Connect the fixture ONLY to the power sources of the correct voltage using the plug received.

    • The fixture should only be cleaned as directed. Always seek service for your system by qualified service personnel if any of the following occur:

    1. The fixture shows a noticeable change in performance. 2. The power-supply cord or plug is damaged. 3. The fixture has been dropped, or the exterior is damaged.

    Please read this manual thoroughly prior to installing or operating the ILUMINAR iLi6.

    Pre-Install Information ........................................

    Technical & Physical Specifications......................

    Hardware & Accessories ....................................

    Connections & Hanging Instructions ....................

    Mounting Instructions ..........................................

    Wiring Diagram .................................................

    Important Cautions & Warranty ...........................

    2

    3

    4

    5-6

    7

    8-9

    10

    1-877-540-5588 iluminarlighting.com

    [email protected]

    © Copyright 2021, ILUMINAR LightingSubject to change without notice.

    iLi6 630W LED SPECTRUM

    WAVELENGTH NM

    LED Lighting Solution

    112

    8 m

    m /

    44.

    41”

    1086 mm / 42.76”

    58 mm / 2.29”

    PHYSICAL SPECIFICATIONS

    LengthWidthHeightWeight

    1128mm1086mm58mm17.6kg

    44.41"42.76"2.29"

    38.8lbs

    VOLTAGE AND AMPERAGE

    120V208V240V277V347V 1.79A

    5.38A3.03A2.63A2.27A

    621W

    646W630W631W629W

    MODEL: WATTS: 630W2.7

    VOLTAGE: 347-480V

    SKU: IL-i627FSG-480

    120-277V

    IL-i627FSG-120

    Rated Mains VoltageVoltage Range (+/-10%)PPFEfficacyInput PowerMin Power FactorTHDCrest FactorBTUMains FrequencyDimming TypeDimmableAmbient TemperatureMax. TemperatureRelative HumidityPlug TypeColor TemperatureColor Rendering IndexFinishing Mounting HeightEmitter CoolingLight Distribution +/- 5%Waterproof RatingLED Lifespan (90% of Life)

    1700 µmol/s2.7 µmol/J

    630W0.9

    < 10%0.992155

    50 / 60Hz0%-100%

    0 - 10V Controllable14º -104º F (-10º to 40º C)

    75°C/167°F98%

    Power Cord Sold Seperately 4000k

    886-12”(15-30cm) to top of Canopy

    Passive Cooling125º

    IP66 for Damp/Wet Conditions36,000+ Hours

    TECHNICAL SPECIFICATIONS

    120-277V AC100-277V

    347-480V AC347-480V

    MOUNTING & COVERAGE

    1.2m / 4'

    1.2m / 4'15-

    30cm

    / 6-

    12”

  • 4

    HARDWARE AND ACCESSORIES

    The iLi6 can be hung from rope ratchets or can be mounted to a rack.

    Before you begin installation, check that you have all the necessary parts to begin.

    1 iLi6 Fixture

    4 hanging rope ratchets with attached cylindrical locks for hanging

    IN THE BOX

    1-877-540-5588 iluminarlighting.com

    [email protected]

    ASSEMBLY INSTRUCTIONS

    © Copyright 2021, ILUMINAR LightingSubject to change without notice.

    Open the package and take out the LED grow light and place it on the table.1

    ! CAUTION when handling your ILUMINAR iL Fixture. The LED array should NOT come in contact with sharp objects. DO NOT touch diodes or apply direct force to the diodes as this can/will cause permanent damage.

    Unfold the LED grow light fixture and ensure the light output surface faces the table.2

  • 7

    61-877-540-5588

    iluminarlighting.com [email protected]

    HANGING INSTALLATION

    © Copyright 2021, ILUMINAR LightingSubject to change without notice.

    Lift the LED fixture and hang it on the long S-hooks.5

    To Suspend Mount (default), use the 4 hanging rope ratchets that come packaged with this fixture and hang them from the ceiling.

    6

    Then lift the LED fixture and hang it from the rope ratchets.7

    Take out the lock-shaft and lock the attachable end cap.3

    There are two ways to mount your LED grow light fixture: Suspending Mounting (default) and Surface Mounting. Surface Mount using long S-hooks (not provided) to hang the fixture from shelving.4

    SURFACE MOUNTING INSTRUCTIONS

    SUSPENDED MOUNTING INSTRUCTIONS

  • 1-877-540-5588 iluminarlighting.com

    sales@iluminarlighting.

    9

    8

    Cable Logic Main-Line AC Extension Cable

    Cable Logic Multi Joint / Junction Main-Line AC Connector

    Cable Single Joint / Junction Main-Line AC Connector

    Panel Mount

    Panel Mount

    Cable Logic Dimming Cable

    Cable Logic Dimming Cable

    Cable Logic Secondary AC Extension Cables

    WIRING DIAGRAM

    1.5m / 5ft

    0.3m

    / 1

    ft

    Female

    Female

    Male

    © Copyright 2021, ILUMINAR LightingSubject to change without notice.

  • 10

    CAUTION

    1. Leave at least one inch of space between the fixture and the mounting area for maximum performance and lifespan.

    2. ALWAYS wear protective eye wear when looking directly at the diodes to prevent eye damage.

    3. The LED array should NEVER come in contact with sharp objects.

    4. Do not touch or apply force to the diodes - this will cause permanent damage.

    5. Only handle, clean or move fixture when it’s unplugged and completely cool.

    6. Keep the fixture free of dust, debris, deposits to ensure the maximum potential of the fixture.

    7. NEVER use cloth to clean the diodes. This will scratch the diodes and could potentially break or dislodge them.

    8. DO NOT use chemicals to clean the fixture. Use ONLY low pressure air or low pressure water to remove dust and debris.

    9. DO NOT exceed 70% max load for breakers due to Inrush current in LED fixtures.

    Please read the following list carefully prior to beginning installation.

    At ILUMINAR, we stand behind our products and our technology as well as our customers. All ILUMINAR LED fixtures are backed by our 5-Year Guarantee. Please visit our website iluminarlighting.com/warranty for

    more information.

    1-877-540-5588 iluminarlighting.com

    [email protected]

    GUARANTEE