Unbranded UB-15MS10 MotherboardReplacement

Written By: Matthew Sylvia

Unbranded UB-15MS10 Motherboard Replacement Draft: 2017-07-20Guide ID: 87966 -

This document was generated on 2019-10-09 08:12:22 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 8

TOOLS:iFixit Opening Tools (1)Spudger (1)Phillips #00 Screwdriver (1)Portable Soldering Iron (1)

PARTS:Unbranded UB-15MS10 Motherboard (1)

Unbranded UB-15MS10 Motherboard Replacement Draft: 2017-07-20Guide ID: 87966 -

This document was generated on 2019-10-09 08:12:22 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 8

Step 1 — Motherboard

Use an opening tool to pry off the memory card door located on the back of the tablet.

Step 2

Remove the two 1.2mm screwsfound under the memory card door.

Unbranded UB-15MS10 Motherboard Replacement Draft: 2017-07-20Guide ID: 87966 -

This document was generated on 2019-10-09 08:12:22 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 8

Step 3

Pry around the outside carefully using the black spudger to get in. Putting many opening toolsaround the edge helps keep it from sealing shut again.

Step 4

Remove the ribbon cable by using the black spudger to release the tab and carefully pull out theribbon cable.

Unbranded UB-15MS10 Motherboard Replacement Draft: 2017-07-20Guide ID: 87966 -

This document was generated on 2019-10-09 08:12:22 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 8

Step 5

Peel up the grey tape so that you can get to the board and untape the ribbon cable that wasremoved from the motherboard in the previous step.

Step 6

Remove the five 1.2mm screws from the board.

Unbranded UB-15MS10 Motherboard Replacement Draft: 2017-07-20Guide ID: 87966 -

This document was generated on 2019-10-09 08:12:22 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 8

Step 7

Use an opening tool to remove theboard from the case.

Step 8

Detach the three ribbon cables using spudger in the first picture. Then cut the black, white, and redwires shown in picture two.

Unbranded UB-15MS10 Motherboard Replacement Draft: 2017-07-20Guide ID: 87966 -

This document was generated on 2019-10-09 08:12:22 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 8

Step 9

Unscrew the two 1.2mm screws ofthis component, which is wired to themotherboard.

Step 10

Unscrew the two 1.2mm screws ofthis component, which is also wiredto the motherboard.

Unbranded UB-15MS10 Motherboard Replacement Draft: 2017-07-20Guide ID: 87966 -

This document was generated on 2019-10-09 08:12:22 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 8

To reassemble your device, follow steps 1-10 in reverse order.

Step 11

Remove old motherboard fromtablet. Take the new motherboardand splice the black wire of theboard to the black wire of thebattery. Do the same for the whiteand red wires.

Unbranded UB-15MS10 Motherboard Replacement Draft: 2017-07-20Guide ID: 87966 -

This document was generated on 2019-10-09 08:12:22 PM (MST).

© iFixit — CC BY-NC-SA www.iFixit.com Page 8 of 8