8/10/2019 UK Kliptec400

1/2

KLIPTEC 400

Product information KLIPTEC 400 made from aluminium

Simple installation by means of a clip over arrangement

The Product

The aluminium KLIPTEC 400 is the

new EasyClip raised seam roof

system from Corus. KLIPTEC has asingle cover width of 400 making it

not only very simple but also extre-

mely quick and economical to install.

The KLIPTEC 400 aluminium sheets

can be used as a roof covering for

domestic, commercial and industrial

buildings accommodating various

roof configurations, both insulated &

uninsulated. What is unique about

the method of fixing is the strength

given by the longitudinal edge when

the two raised seams are interlocked.Their secure connectivity prevents

high wind suction loads from peeling

open the side lap.

Product Advantages

Simple, non-penetrative installation

in most weathers

No additional fastening components

No special tools required

Extremely economical single width

sheets

Highly durable aluminium alloy

Easy to handle quick to install

Fully recyclable

Areas of use

KLIPTEC 400 raised seam system

can be used for a roof pitch of approx.

3 degrees and above.

Forming the outer sheet of a warm

roof construction with insulation

and various supporting liners &

decks such as trapezoidal profiles

or timber work

As the outer sheet for cold roof

construction with ventilated void

beneath

For renovation, repair and

remedial work

For private housing

For industrial buildings

For commercial buildings

8/10/2019 UK Kliptec400

2/2

KLIPTEC 400

Product information KLIPTEC 400 made from aluminium

Simple installation by means of a clip over arrangement

Range

0,8 16Alumin ium

Stucco embossed

Thickness Profile length Material/surface finish

mm max. L/m

EasyClip

Incredibly quick and easy installation!

KLIPTEC 400 made from aluminium

can be quickly and simply installedby hand. Firstly, the roof area is

divided up in accordance with the

modular width of the raised seam.

When installing sheet on steeper

roof pitches, the longitudinal joint

can be made with the help of arubber hammer. A completed roof

area can therefore be achieved in

a very short time.

Technical data

Load span tables are available on

request. Fasteners & performance

together with any additional technicalinformation are available on request.

Figure 1

The first sheet is secured to the

structure via fasteners through the

retaining edge.

Figure 2

The next sheet is installed over the

longitudinal secured seam.

Figure 3

The raised seam is finally locked

together metre by metre by firm even

foot pressure.

1 2 3

Printed

on

chlorine-fre

e

bleached

paperD-1108

03/03

Corus Bausysteme GmbH

August-Horch-Str. 20-22 D-56070 Koblenz

Postfach 1003 16 D-56033 Koblenz

T +49 (0) 261/891-0 F +49 (0) 2 61/8 20 38

kalzip@corusgroup.com

www.kalzip.com

The information and product descriptions contained in this publication are provided to

the best of our knowledge and are based on our experience and studies. They do not

refer to any specific application and cannot give rise to any claims for compensation.

We reserve the right to make any changes to the construction or product range which

seem technically sensible in view of our high demands for quality and progress.

Copyright 2003 Corus Bausysteme GmbH