TXT Full Cover Dash - Buggies Unlimited

1
Full Dash Cover TXT Models Remove the steering wheel and cut out a 4"X15" area out of the O.E.M. dash (A). Install the Radio/Speakers into new dash. Slide dash over steering column and set into car dash area. To support the radio use a piece of 3 3/4" Aluminum or steel (1/8" thick) and bend at an angle to fit the rear mount stud on radio. The other end mount to the driver's side compartment (C). Route all wiring at this time. Install six #6 X 1/2" screws spaced evenly to secure the dash to car (D). Install the three mounting bolts supplied with kit. Drill through floor for bolt installation (5/16" drill). One more will be found under lid (E). A C D E (B) Mounted To Car B Note: move the key switch and plate as shown in (B).

Transcript of TXT Full Cover Dash - Buggies Unlimited

Page 1: TXT Full Cover Dash - Buggies Unlimited

Full Dash Cover TXT Models

Remove the steering wheel and cutout a 4"X15" area out of the O.E.M.dash (A). Install the Radio/Speakersinto new dash. Slide dash over steeringcolumn and set into car dash area. Tosupport the radio use a piece of 3 3/4"Aluminum or steel (1/8" thick) and bendat an angle to fit the rear mount studon radio. The other end mount to thedriver's side compartment (C). Routeall wiring at this time. Install six #6 X 1/2"screws spaced evenly to secure thedash to car (D). Install the three mountingbolts supplied with kit. Drill through floorfor bolt installation (5/16" drill). Onemore will be found under lid (E).

A

C

D

E

(B) Mounted To Car

B

Note: move the key switch and plateas shown in (B).