Twist Wire Bracelet
-
Upload
gabriela-pisica -
Category
Documents
-
view
8 -
download
2
description
Transcript of Twist Wire Bracelet
How to make twist wire bracelet
STEP 1 - Firstly select beads you want to use, smaller beads will give more dainty bracelet. I used green agate, malachite chips, green cats eye beads and toho beads for this project. I used 26 gauge silver coloured florist wire you will need about 4ft x 2.
STEP 2 - Use one length 26 gauge wire at a time. Leave tail of about 6 inches place on bead i usually use round one on wire.
STEP 3 - Cross wires right under the bead as shown in the photo, then twist 3 times
using thumb and forefinger.
STEP 4 - Twisted bead will be held in place on 26 gauge wire now. Take a finger space between this bead and the next one and do same mixing up beads and shapes as you go to create interest.
STEP 5 - Mix up seed beads and round beads the closer the beads the more wire you will use. Check length around your wrist you will need extra as you will intertwine the 2 strands later.
STEP 6 - Repeat with other strand. Leave tails of 6" either end.
STEP 7 - Grasp two ends and make Y shape then twist with thumbs and forefingers about 1/2 "
STEP 8 - You need enough twisted wire to be able to make a loop with round nose pliers.
STEP 9 - Twist loop with round nose pliers and bring two ends around base of it to secure. (You could add lobster clasp at this point if you want to. so it is secured onto the loop and cannot come off.
STEP 9 - Plait and intertwine the two strands (careful not to overtwist or the wire will snap) and then the two ends by the twisted wire loop you will individually weave one at a time amongst beads until left with about 1" wire then use round nose pliers to create nice neat coil and tuck in amongst beads. Do this with all four ends.
STEP 9 - You will see i have added jump rings to the twisted wire loops you made and a mobius love knot (intertwined jump rings) and clasp to add some decoration to the bracelet.
You could make a necklace in the same way as this but longer length too and its great little project to use up all those little beads you have left over.
Time to make : approx 30 to 45 mins. Level Beginner to intermediate.