Tools you will need #8 Torx driver #10 Torx driver Standard Phillips screwdriver Small...
-
Upload
myron-jacobs -
Category
Documents
-
view
225 -
download
3
Transcript of Tools you will need #8 Torx driver #10 Torx driver Standard Phillips screwdriver Small...
Tools you will need
• #8 Torx driver
• #10 Torx driver
• Standard Phillips screwdriver
• Small (jewelers)Phillips screwdriver
• Small standard screwdriver
With the autoloader upside down, remove 4 #10 Torx screws
1
2
3
4
Slide the outer case towards the back of the drive and remove it
Removecase
Turn the autoloader top up and remove 4 Phillips screws (2 on each side) from the inner case
1
2
3 and 4 areon the otherside
Slide the tape and carousel mechanism towards the front of
the drive face about 3 inches
Pushout
Remove data cable and 4 wire connectors from the mechanism
Data cable
4 wire connectors
1
2
3
4
The number one connector can be removed from the top of the drive prying it toward the center of the drive and pulling it out the
back
Remove mech from housing by sliding it out the front
Carouseland tape Drivemechanism
Tape drivehousing
remove
From the back of the drive remove the 2 #8 Torx screws that hold the drive retaining bracket
in place.Retaining bracket
2 #8 Torxscrews
Lift the drive ¼ inch and pull retaining bracket up and out
Retaining bracket
Lift up ¼ “
Continue lifting drive to 60 degree position
Pull drive out and lay upside down on top of carousel
Drive
Auto-loader
You can see the magazine inside the carousel
Magazine
Remove magazine from carousel by lifting up