TIMBER DOCK SYSTEMS - Bellingham Marine Industries
2
Engineered for optimal performance, Bellingham Marine’s Timber Dock Systems provide tremendous strength and stability. Upgraded interior components and the use of a torsion beam make Bellingham’s tim- ber system up to 20% stronger and 30% more stable than traditional timber framed systems. TIMBER DOCK SYSTEMS For those that love the natural look and feel of a timber dock system.
Transcript of TIMBER DOCK SYSTEMS - Bellingham Marine Industries
Engineered for optimal performance, Bellingham Marine’s Timber Dock Systems provide tremendous strength and stability. Upgraded interior components and the use of a torsion beam make Bellingham’s tim-ber system up to 20% stronger and 30% more stable than traditional timber framed systems.
Pantone 295 CVC
Pantone DS 214-2 C
C: 0 M: 0 Y: 0 K: 70
C: 0 M: 0 Y: 0 K: 100
TIMBER DOCK SYSTEMS
For those that love the natural look and feel of a timber dock system.
decking
stringers
waler
cross beam
flotation
TIMBER DOCK SYSTEMS
Mainwalk
widths: 6, 8, 10, 12, and 14 feet(measurements are nominal)
lengths: 32’ (typical module length)
Finger Piers
widths: 3, 4 and 5 feet(measurements are nominal)
lengths: custom
ExPlODED VIEw - MaInwalK
Interior Components: All inte-rior components are southern yellow pine, pressure treated in accordance with AWPA standards. All interior components exceed industry stan-dards and connections are steel rein-forced.
Exterior Frame Components: Stan-dard walers are mechanically lami-nated, southern yellow pine, grade #1. All exposed edges are re-milled and eased at termination points.
Steel Components: All steel com-ponents are hot-dipped galvanized per ASTM A-153. Structural mem-bers are fabricated from ASTM-A-36 grade steel.
Decking: #1 grade, southern yellow pine engineered for this application comes standard. The timber is mold-ed 2x6 material with radiused edges; relief cuts are placed on the bottom face and the timber is impregnated with a moisture inhibitor during the treatment process. Alternative deck-ing options are available.
TECHNICAL DATA
DESIGN LOADS
Live Loads: The dock system shall support up to 50 PSF or a 500 lbs concentrated load on any 2’ square. The dock shall have not more than a 6º tilt from horizontal.
Dead Loads: Flotation shall be de-signed to support the dead load plus up to 50 PSF live load with a mini-mum freeboard of 9”.
torsion beam
Bellingham Marine Timber DivisionPO Box 16054, wilmington, nC 28408ph. (910) 790-0313 fax (910) [email protected] www.bellingham-marine.com © 2011 Bellingham Marine
For more information about our Timber Dock System call
910-790-0313 or 800-733-5679.
