The Construction of 9-12 Volt Dc Power Supply
-
Upload
suardi-f-seiei -
Category
Documents
-
view
160 -
download
2
Transcript of The Construction of 9-12 Volt Dc Power Supply
MINI PROJECTTHE CONSTRUCTION OF 9-12 VOLT DC POWER SUPPLY
NAME : SUARDI BIN NANANGMATRIX NUMBER : D20091035131
OBJECTIVESRecognize some of the electronic
components.Gain experience in assembling and
soldering components to the circuit board.
Check and test components such as diodes, LED and resistors.
Test and measure some parameters of the power supply.
Trouble shooting for the faulty components and power supply.
APPARATUS
Step-down power transformer (0 - 9) volts.
Plastic casing.
AC switch (ON – OFF)
APPARATUS
Diodes (4 units), 1N4001 or higher
Capacitor (2200 µF , 35 volts rating)
Binding post (1 red and 1 black)
APPARATUS
LED (Red or Green or Yellow)
Strip-circuit board (PCB).
Resistor
APPARATUS
Solder
Wire
PROCEDURES
Circuit configuration
PROCEDURES
Circuit configuration
PROCEDURES
DATA AND ANALYSIS
AC output of your power transformer
10.86 V
DATA AND ANALYSIS
DC output of your power supply
13.98 V
DATA AND ANALYSIS
output ripple of your power supply
1.1mV
ripple factor of your power supply
Ripple Factor =0.008%
PRECAUTIONCheck all diode and LED to make sure they
are in good condition using ohmmeterMAKE SURE the positive (P) and negative (N)
polarity of the diodes are correctly connectedProperly solder all components leads to the
circuit board. Make sure there is no dry -joint or short circuit between copper tracks of the circuit board
Make sure cut short all the components leadsMake sure connection made between wire are
insulate properly to avoid contact
FINISH