7/18/2019 tgs2-ans

http://slidepdf.com/reader/full/tgs2-ans 1/3

TASK 3

• Step 2

As soon as you press the Enter key, Cisco IOS debug output informs you that there is

now a route, but its state is False In other words, the route has not yet been added to the

routing table !hy did this occur  and what steps should be taken to ensure that the routeis entered into the routing table"

is_up: 0 state: 6 sub state: 1 line: 1 has_route: False muncul karena status dari interface

fastethernet #$# masih dalam keadaan shutdown Sehingga, agar route yang telah

ditambahkan pada interface fastethernet #$# masuk ke dalam routing table, maka interface

fastethernet #$# harus diaktifkan dengan menggunakan perintah no shutdown

• Step %

& Check your physical connections to the 'A( interface Is the correct interface

attached" Yes

)our router may ha*e more than one 'A( interface +id you connect the correct

'A( interface" Yes

An interface will not come up unless it detects a carrier detect signal at the hysical

layer from another de*ice Is the interface connected to another de*ice such as a hub,

switch, or C" Yes

2. Check link lights Are all link lights blinking" Yes

3. Check the cabling Are the correct cables connected to the de*ices" Yes 4. -as the interface been acti*ated or enabled" Yes

• Step .

R1# show ip route

• Step /

Some IOS *ersions display the output shown abo*e e*ery %# seconds !hy is the state of 

the route still False" !hat step must you now take to make sure that the interface is fully

configured"

is_up: 0 state: 0 sub state: 1 line: 0 has_route: False muncul karena status dari interface

Serial #$#$# masih dalam keadaan shutdown Sehingga, agar route yang telah

ditambahkan pada interface Serial #$#$# masuk ke dalam routing table, maka interface

Serial #$#$# harus diaktifkan dengan menggunakan perintah no shutdown

• Step 0

7/18/2019 tgs2-ans

http://slidepdf.com/reader/full/tgs2-ans 2/3

R1(confg-i)# no shutdown

• Step 1

R1(confg-i)# no shutdown

& Check your physical connections between the two !A( interfaces for & and 2 Is

the correct interface attached" Yes

)our router has more than one !A( interface +id you connect the correct !A(

interface" Yes

An interface will not come up unless it detects a link beat at the hysical layer from

anotherde*ice Is the interface connected to the other router3s interface" Yes

2. Check link lights Are all link lights blinking" Yes

% Check the cabling & must ha*e the +CE side of the cable attached and 2 must

ha*e the +4E side of the cable attached Are the correct cables connected to therouters" Yes

. -as the interface been acti*ated or enabled" Yes

• Step &#

R1# show ip route

R2# show ip route\

TASK 6

• Step &

From the host C&, is it possible to ping the default gateway" Yes

From the host C2, is it possible to ping the default gateway" Yes

From the host C%, is it possible to ping the default gateway" Yes

& Check the cabling Are the Cs physically connected to the correct router" Yes

5Connection could be through a switch or directly6

Are link lights blinking on all rele*ant ports" Yes

2 Check the C configurations +o they match the 4opology +iagram" Yes% Check the router interfaces using the show ip interface brief command

Are all rele*ant interfaces up and up" Yes

• Step 2

From the router 2, is it possible to ping & at &02&/2&" Yes

From the router 2, is it possible to ping % at &12&/7&&" Yes

7/18/2019 tgs2-ans

http://slidepdf.com/reader/full/tgs2-ans 3/3

& Check the cabling

Are the routers physically connected" Yes

Are link lights blinking on all rele*ant ports" Yes

2 Check the router configurations

+o they match the 4opology +iagram" Yes

+id you configure the clock rate command on the +CE side of the link" Yes3. -as the interface been acti*ated or enabled" Yes

4. Check the router interfaces using the show ip interface brief command

Are the interfaces up and up" Yes

• Step %

From the host C%, is it possible to ping the host C&" (oFrom the host C%, is it possible to ping the host C2" (o

From the host C2, is it possible to ping the host C&" (o

From the router &, is it possible to ping router %" (o4hese pings should all fail !hy"

8arena pada router &, 2, dan % belum dikonfigurasi routing9nya Sehingga, semua

 percobaan ping di atas gagal

TASK 7

• Step &

Are all of the rele*ant interfaces on each router acti*ated 5that is, in the up and up state6"

Yes

-ow many interfaces are acti*ated on & and %" Ada 2 interface yang aktif pada & dan

ada 2 nterface yang aktif pada %

• Ste